Search results

The B&O system is no doubt the worst premium factory audio system I have heard. The speakers are cheap and low quality and so is the amp, it all needs to be replaced. We have teamed up with morel to make a complete kit including all speakers, this will be on sale in a few months. If you can't...

You'll want minimum 80A If you'd like you can order another cable from us directly, just email me

I would highly recommend an A2B interface, this will allow you to remove the factory amplifier which is most likely the source for your issues here. You are fighting the factory eq-ing, even if you use input equalization you're still fighting phase filtering which the musway DSP cannot correct...

Yes just B&O for now. We are in the middle of development for the regular B&O

Of course! If you're part of the mObridge family we will always look after you! I have to clear Roys name of any install error too! The issue turned out to be a wrongly pinned harness in the end.

Email me lots of photos and I'll see what's going on

Sounds like you may have missed the flat 4 pin connector that comes off the main harness and plugs into the back of our amp

I think they are planning to sell the sub separately

Around 2 months away I believe.

Easiest way to improve on the base tune is to leave the crossover points alone and just level match the channels with a calibrated mic for your setup and knock out the largest peaks. When starting out the less eqing the better results youll get. Dont over do it!

Shoot me a PM and I'll give you the part number.

@Gotchaa Has this setup. Ill let him give you his review

Coming soon! maybe 2-3 months.

If you pull the fuse out you will still be able to operate everything else in the car. Give me a ring and we can figure out what's gone wrong 213 401-0127

These are two separate solutions. Our all-in-one amp is an actual 9 channel amplifier that replaces the factory B&O amplifier and takes A2B directly in. It is like a kicker amp but on steroids and with a Harvard education. Amp link...

We have actually had a dealer install our amp in a 2 door and mount it in the inner fender area on a small L shape bracket they made. Could be an option too if you have the equipment.

So it will fit in a 2 door if you use a tailgate mounted subwoofer and a mti accoustics amp mount board. Given you won't use our amp mount plate we can remove that from the cost of the kit. Shoot me a pm for more information. We are the only intergrated A2B Amplifier on the market, so if we...

This is a new issue I have not seen, I'll have to look into it via a remote session at your next convenience

C1s are rated to 50w, we push 150w to the kick panels. The gain will just need to be dropped down a couple db on those channels, that will be the issue

This has been a common point of feedback for the install. Clearly I have doll hands!