Search results

I toad from Florida to Moab took over 300 miles to burn off the crud,had to open the windows a few times it was so bad, just did a short trip and 30 minutes took care of it

I have a harbor freight one it comes loose in 100 miles, I see this one is double nutted, i was going to try that but went with the shims instead. also looks like the roadmaster pulls down believe the HF is pulling up.

stock badlands SAS with Rock hard 4x4 bumper about 24" I have a roadmaster 10 riser, lots of slop in the riser hitch up & down and side to side my Rv has a 2.5" receiver so I have a 2.5 - 2" reducer. beginning of trip i made "L" shims to take out slop had 4 of them on top and 3 on side, top...

I have pictures in this thread somewhere, posted them back in November

I'm in Cape Coral area I'll try here and North

how far southwest FL did you call? might save me some time?

I did it myself, had everything in the garage. I did try and farm it out check market place for woolwax or fluid film or check them 2 websites for local that do it, in my case they were 2-3 weeks out and I didn't want to wait that long.

Just got a FL quote $400 yr more than PA $366 / 6 mo PA $562 / 6 mo FL

Wrong link on the charger,but they are out of business, there are others out there. You can get. 7 pin RV Y plug and sockets to run the wireless lights and a charger if needed. I use the NSA system.

I have these wireless lights https://www.amazon.com/dp/B0936C6SCZ/?coliid=I4TQ8QO78E4DH&colid=71APS3CUO1WP&psc=1&ref_=lv_ov_lig_dp_it for the charger I got mone of these, not installed yet made by LSL products but googling the link looks like the owner is dead and no long in bussiness ...

here is the part number ML3T-1A180 TIRE PRESSURE MONITORING SENSOR also says TPMS 68

thought i did that the day it sold

Getting Started: Before you begin, you will need to drive your vehicle above 20 mph for at least two minutes. Then park in a safe location where you will have access to an air pump. Might need to set the park brake, have not confirmed yet Ford Tire Pressure Monitoring System (TPMS) Reset...

I ordered the rear rack cross member in November, still waiting on it.

28 pounds https://www.rockhard4x4.com/product_p/rh-60240.htm

my Rock Hard bumper came with Mopar ( jeep) retainers, no idea the part numbers

rock hard 4x4 makes tabs to match the tow bar, that replace the Mod bumper tow hooks down fall is you lose the tow hook, with their bumper they have a new tow hook on the bumper link to roadmaster tow tab https://www.rockhard4x4.com/product_p/rh-8002-rm.htm

If I were to do it over for the Mod bumper,I would order the Rock hard 4x4 tow bar adapters ( replaces the tow hooks ) and the lod brackets for the break away Cables, cost would be minimal this way.

Yes, no idea what went on, tried it a few times again and work's every time.

Post #568 in this thread Post in thread 'Flat tow equipment needed to flat tow the 2021 Bronco?' https://www.bronco6g.com/forum/threads/flat-tow-equipment-needed-to-flat-tow-the-2021-bronco.19759/post-1665023 I ran the NSA cables thru holes in the strut towers, it was a straight shot for both...