Search results

Ordered!

Since you're in MO, there should be some fine print on the final page of your extended warranty contract that states you have 30 days to cancel, and the dealer has 45 days to refund the full amount (minus any claims) or be subject to 10% penalty per month. I've attached the last two pages of...

Yeah, out here in St. Peters its still very much Wrangler country. So many Wranglers.

Took my spare tire off today, and the rear sensor did not go off at all. Put it back on and immediately received sensor alarms on drivers side. Problem solved. Ordered the RC relocation kit. Thanks all for the help/suggestions.

I think I've still only seen 2 or 3 in the wild.

Wasn't me unfortunately, I was installing my AIG rear lift struts.

Less than 1500 miles on them. No sensors, used them on my current upgrade. Local pick up in St. Louis/St. Charles/St. Peters only.

Yeah, I'm going to remove the spare and see if I get the same alarms first. If that don't work, I'll set up a dealer appt for recalibration. Thanks for the advice!

None of the sensors were touched that I'm aware of, but it did start immediately after getting my 35's installed. I checked the connections to make sure nothing was loose, all good there. How do you get the sensors re-calibrated?

Awesome, thank you so much!

Good idea, I'll give that a shot. Do you know which relocate kit will work with the Bronco?

Yeah, was hoping that it just needed to self-adjust, but has happened both times I've driven it since getting the new tires.

I have a non-Sasquatch OBX and added 35's with only a 1" front end level. Crash bars had to be removed.

I couldn't find much on the subject with a search, so here we go. Immediately after upgrading my OBX with 35" tires, my rear drivers side sensor will go off when I put the Bronco in reverse. This will happen regardless of where I'm located (garage, empty parking lot, etc). I suspect the spare...

Do you think the Ford accessory rocker panels that are used to hide the pinch weld can be left on? Or will that have to be removed before installing the AMP steps?

Can you keep on the Ford rocker panels that are used to hide the pinch weld? Or will that have to be removed before installing the AMP steps?

Part No: VM2DZ16C900A This is the one without the lip on the top. Asking $50 ($89 on Ford Accessories page). No shipping, local pick up only in St. Charles/St. Peters please.

Following. This is my next big purchase, but have to recover from recent wheel/tire purchase first.

Your Bronco was definitely my inspiration the moment I saw it. Luckily we're far enough away from each other we wont awkwardly run into each other wearing the same thing!

Thank you! @JCAntimatter was definitely my inspiration, so I can't take full credit in wheel choice. The guys at @chris@pandamotorworks got me the Zone Offroad 1" level kit and a couple hours in labor including the install/mount/alignment. Overall very happy with everything so far.