Search results

Ya I haven’t turned mine up more than 16 and that was full speed down the highway with the top off. The wife complained it hurt her ears lol.

Make sure your radio detect button is on. That will stop the popping.

You don’t use red. You’ll cut off the red and black wires that have the connections that would typically hook to the battery.

Ya I had a spot like that on one of the roll bars towards the rear. Not too noticeable unless you’re looking for it. I suppose you could try to warranty it but not sure how much of a fight it would be.

Done! Followed on instagram

I work with galvanized sheet metal daily and I can tell you it will definitely rust over time. It helps prevent it but it’s inevitable especially if it’s exposed to salt and moisture.

There’s actually a ton of stuff you can find on here. Scroll down to sponsorship marketplace. Good luck!

They do have bronco stuff….but whatever you do avoid ordering from them. I had a big issue with some Rock rails I ordered. They basically refused to send me part of my order that I paid for. Fought on the phone every day for about a month. Trust me when I say Avoid them at all cost lol. There’s...

Since rumor has it the mod top MIGHT be available for 2023 I’m thinking the heritage edition will likely be released. With that probably a couple colors only available on that trim.

I’m not certain on this harness but there’s two wires at the Switch most likely. One will go to your aux switch other to ground.

Looks like you just pull up on that latch

I’m thinking they open from the inside. Keeps it clean looking.

Don’t really think the price is terrible but ya. Probably at least 1k for paint. You’ll be in over 3k all said and done.

Pm me with you info

Ground wires all all together and grounded on the post near where the aux wiring is.

6 of each

I tied all blue wires together to switch one those are the white LED. All white wires together to switch 3 those are the amber drl.

I ended up using two switches. Switch one (30 amp) for the white LED. And switch 3 for the drl. The total amps for 6 lights was 18 amps so if you want them all on one you have to use switch 1 and I’m ok with it. Switch 2 should be plenty for most light bars that’s my plan for switch 2.

Took about 2 1/2 hours. The most time consuming part honestly was adjusting the lights. The bolts are hard to get to on top so I had to keep on removing the whole assembly to make adjustments. It’s worth it though gives me the look i was going for at a fraction of the price of most of the other...

I got the ambers. Looks great with the running lights!