Search results

Got the kick panel speakers in finally. The driver side panel is a complete b**** to get out. It was plastic riveted to the dead pedal. Why? Who the hell knows. Popped the 5 or so rivets with a trim tool and it slid right out. Might put piece of felt between them but no noticeable buzzing...

Aren't you a 7/13 reservation? I usually go to a self service place and bring a wash mitt. Soap it up, scrub it down real quick and then rinse. 10 minutes tops for a "quick" wash.

Has anyone had success removing the driver side kick panel? It seems like it's got a real good attachment to the side of the dead pedal. Thank

I've got the 2.7 which is more than enough from my perspective. Stayed with the MGV since I wanted the rubber floors for all our shore trips. I find them super comfortable. Heat wise from them I haven't had much of an issue so far. The AC is A++ I was part of the group buy at Brewster NY...

I'm assuming the plant. I'll shoot an email to my sales guy to double check. Here's the speakers KICKER CS Series CSC4 4 Inch Car Audio Speaker with Woofers, Yellow (2 Pack) https://www.amazon.com/dp/B07NS9FVKB/ref=cm_sw_r_cp_api_glt_fabc_G1ZN60446YM5XNJNPX3N?_encoding=UTF8&psc=1 KICKER CSC65...

Took it the top all the way back for the first time. Noticed the top frame already had some thick PPF and felt pads on it. Also noticed it on the rear corners too. I guess they had issues here too. Also swapped in new 4"inch speakers. Makes a world of difference. So much more clarity...

I had the same issue. I adjusted the hood bump stops by a turn lower each and now it closes fine.

Damn you remind me of someone. Can't put my finger on it

Oh 2.7 does have a boost gauge. Thought I'd read it doesn't.

It'll be quieter then having it outside with me or under the hood.

I'll have to do a relocation kit and fab up a bracket till something legitimate comes out. I've seen jeep kits like this with the filter and chuck mounted near the rear roll bar mounts to the body.

Did a bit of test fitting while I could stand this unbearable heat. ARB single will fit in the rear storage cubby with a bit of finagling. Now to figure how to mount it in there.

I'd ask for a new one to be on the safe side but I was under the impression any soft top built starting in September will get it.

I'll give you 20 bucks for it?

@Baja Designs any plans of selling just the mounting plate and maybe upfitter wiring? I currently already have a set of squadrons and s2's that were from my previous Tacoma. I figured I could save a bit getting just the mounts instead of trying to sell my existing lights and buying the whole...

Also reading comprehension doesn't mean I can write good 😂

Touche. Oh well

God there is a lot of people with reading comprehension issues in the rest of this forum......Or they're all trolls. Haven't figured it out yet.

Correct, my 7/22 build has it