Search results

I'm planning to add a flyback diode to the 12v solenoid inductor side, anybody else do that ? IN4001 or IN4007

Bluesea 3000 series rated 600a

Warn puts out a winch isolator kit that has a solenoid. It's only rated for intermittent usage, and I don't think it's rated for 500 amps. I've seen people on YouTube use this. Is this good enough? https://www.warn.com/power-interrupt-kit-62132

I finally did this.

I like the idea BigMeatsBronco came up with mounting the hi lift above the roll cage in the back. I took that idea modified it a little bit to make it higher so that my rear view dash camera still works, and I don't have to drill a hole in the hi lift. Here my test fit, still need to paint it...

Is the C1000 Anker better than the Jackery 1000 V2, seem like they are the same

ITs from Ford Quality is #1

4. Specific question about the ARB wiring, I am planning on using the ARB switch instead of an uplifter and there are two cables that I'm not exactly sure where to run them to. The first is "to ignition" and the second is "to dash illumination". From what I understand the ignition one just needs...

I have a bike mount that attaches to the spare tire, it worked well on my Isuzu rodeo 4x4. It came with a extra mounting hardware that allows for different wheel lug patterns, unfortunately I couldn't use it because the bronco has a rear view camera. I paid $50 on craigslist for this and I...

Where and what dealership is this so we can avoid them.

Ford has a 20% sale right now. And if you have a Chase credit card that freedom card and you buy from ford.com irs giving it extra 8% . Time to buy it now. Just reuse the same gasket that you have on there now. Torque the bolts to 22 ft lb like someone listed and you'd be good to go. Take the...

I would never go back to them. Who in the world uses a zip tie that would be only for an emergency. If I was you I would check the other side also. Should be a stainless steel band.

Never mind I see the parts list from the previous thread thanks

Where did you get the hardware for that? What size thread in bolt?

What size thread are on the roll bar? What did you use to mount them is there a parts kit for that? Looks like the perfect spot.

You can use the front recovery point on a stock bronco if you have this device called, "jeep needs sam-3" , if you sport an aftermarket rear bumper with a recovery loop it could work there too. Yes I carry a bottle jack too, but it's useless if you can't get under there, trust me.

What did you use to mount them on the roll bar. What thread size is that ? Do you have a source for parts. Just picked-up a new unused hl485 for $70. Using it also with a lift mate to lift a Tesla to put jacks under it

What is this thing ?

One thing good about the KR mount is that the computer module does not have to be taken off and mounted to the same bracket that holds the compressor. So it's not going to get the heat from the compressor and not as much of a vibration. if you compare the Grimm or SDHQ vertical mount and the...