Search results

Every bit of that I would guess 200 ish. My 2DR is 5500 pounds with a full tank

Bingfu Fakra Z Female to Male Vehicle Antenna Extension Cable 2m 6.5 feet for Car Stereo Android Head Unit GPS Navigation FM AM Radio Sirius XM Satellite Radio 4G LTE TEL Telematics Bluetooth Module https://a.co/d/gQD64in I only needed about a foot so I would probably get the smaller cable they...

Here’s a couple more pictures I also had to order a camera cable extension and washer hose kit to extend the existing ones I was about a foot short of the factory stuff working

Like most of you I waited 2 years for my bronco. Buying parts and stacking them in the shop impatiently waiting to receive my new toy. I ordered my 2DR with the factory winch set up but ford zeroed it and my bronco went into production. Ok no biggie right? So I have had a few LOD bumpers over...

Exactly! Nothing but top tier fuel in my vette As well as my big bore Stroker Hogs and our twin turbo fords. I am spoiled I have a 550 Gal tank of super on my ranch full of chevron with Lucas oil fuel/upper cylinder lube. I too use all of the RPM range with a dash of the Red part

Bill there horrible.

On edit. These tires are for mall crawlers. I have run a mud terrain tire on every 4x vehicle I have owned since I was 16 these Goodyears are the absolute worst I have ever run. I live on a gravel road and they suck. I have 5 for sale and can’t even get a bite for 1000 bucks for 5. I switched to...

MINE WERE OFF WITH 49 MILES ON THEM

LOOKS CLEAN.

So lately I have been thinking about doing the old school hood pins on my WT. I’ve done some searching but can’t seem to find any good pic or install info. Please share any pics or info you got? thanks Steve

Here’s my new plate

Let me try this again

I ordered this one for me it’s SRQ fab in Florida

I’m just north of you in Red Bluff. I can send pics and measurements if you want one for your rig Steve

So I looked at the RCI unit it gives up a bunch of clearance on either side of the differential. The DV8 is a high and tight unit. Now I’m not finished with my hybrid skid plate. Going to cut the front off of the RC plate and weld it to the DV8 as well as weld the two plates together at the...

It’s a nice piece but it needs just a bit more protection

Well I ordered an RC diff cover for the Dana 220 rear of a jeep figuring it’s the same diff right? Nope. Ours has more meat in the bottom of the casting. Fast forward to the Dv8 skid unit. so today the DV8 shows up as luck would have it the bronco was already up on the lift in my shop. After...

My apologies to Icon for the thread hijack Here are some more pics of my end piece of the stock rack with 700 miles onit look at the casting line if you look close you can see the wear/ out of round. I haven’t even had time to wheel it yet so this is all on road wear.

So I’m not sure I don’t have an updated rack in my Sas wildtrak. Non Hoss 3.0 Built 9/13/22 I say this because my inner tie rods are a 38mm wrench not a 32mm? I also think the new ford braptor fanchy smanchy rack will be junk too. Ford does not build billet strong stuff for us guys that are...

Sorry I should have been clearer the end cap of the rack was showing signs of wear. Attached are a few pics of mine. Inside the end cap of the rack there is only a seal. No real support In my opinion. The tie rod operating angles on a lifted Sas will transmit a bunch of force into the rack. If...