I got a ticket when I was lazy to install a relocation bracket that moved the plate from center over the modular bumper to above the bumper on the right side to allow unlimited fog light use.
You get two plates and there are tons of options to relocate it. Asked my dealer to forgo the front...
We did the one in Vegas on a Sunday. When we went in Oct, the late start meant we finished the course at night. It even began to rain and hail on the last trail back to camp.
I had been trying to by the Ford made tailgate table through my dealer and after a number of attempts (Ordered one, they lost it in the dealership etc.) I was going to go through another dealer but the website notes it was 'obsoleted' back in December 2023.
Are they actually not available...
I've had the issue since I took ownership of it. I can easily recreate it by closing the door, slowing it down then completing the door close. It is as if the slight deceleration is causing a sensor to think the door is fully closed when it is not.
When closing the driver's side door, sometimes the window rises up to seal before the door is closed and gets stuck outside the track until I roll the window down and reclose it.
Anyone else have this issue? If I don't close the door in one smooth motion this issue occurs.
I know after a couple of hours sitting my tailbone feels like it is locked in place and if I try to get out of the seat it makes me pay for that privilege. Is the solution as simple as raising the front part of the seat via a jacker?
I would love that but I've heard some stories about black grime along the edges of the vinyl but that voiod just be because of bad film.
Was thinking of the stripe vertically on the hood and hockey stick patterns on both sides.
When I was a kid out family had a blue Izuzu I-Mark in metallic blue with a kinda pearlescent stripes on the bottom of the doors which could be an option. Or maybe even gunmetal.
Can confirm finally that my wipers are acting normally.
I'm getting the same content feeling when Ford finally fixed the issues with the Sync system in my old Ford Edge.
Daytime running lights - after writting vehicle must be in drive to see new state (doesn't work in park)
BdyCM
726-43-01
**xx
BdyCM
726-43-01
xx**
I attempted to change the first set of values for 726-43-01 for a OBX with LUX package with signature headlights from 0202 to these values
*...
It would seem if you want to control the lights with the dome switch, Mabett is the only option, but Mabett seems to have QC issues possibly on the initial batches of their lights.