Search results

Picked these up. Like how they don’t hang down so low. Matches the roast leather seats pretty well. Bronco is stamped on both sides. https://www.etsy.com/listing/1180083658/ford-bronco-leather-and-nylon-grab?ref=yr_purchases

Rx my pins today. Top Notch! Thanks, now don’t need to worry about loosing the only one that came with the bronco.

Definitely not go pro. I’m stumped, I had them in my hardware pouch. Gettin’ old is a b*tch trying to remember.

I’ve had my 2 door top off and mesh top on for so long I forgot where these two belong. I suspect that possibly in the front of the hard top since the best top came with bolts for the cross member.?

Nowhere Kansas

I asked earlier this week. They were still looking for a 2 door.

Doesn’t seem to be binding up. I’ll grab a video this weekend when I remove the top.

I used a step bit and drilled the holes out a little. It’s still a tight fit but did not want slop when the pins were in.

How did you get yours so level when it’s at the top? I’m still working on the balance. When the top is almost to the floor it’s balanced, but when at the top of the ceiling it’s not. I’m womdering if I move the front pulley more towards the front of the vehicle if that would level this thing...

How’s the tilt when it’s up off the bronco? I need to still adjust mine so the a$$ end isn’t lower than the front. Need to find that sweet spot, but I don’t mind lowering it and finding the pins / holes in the back first before the front engages the pin / holes As for the front tube, I left if...

Anyone else had a chance to install with the new parts?

BTW they have only sold 6 of the 2-door setup.

RX the package today w/ the extra parts for the 2-door. At first I was a little frustrated that I still could not get the plate to line up w/ the hole for the pin. I called and spoke to Carter; he said they drilled out those holes to 1/2" so I took a step bit and opened them up to 1/2" - They...

GMTA - I asked the same question Sure would of been nice to see in the video of the top actually lifted off and how well it was balanced. -b

Check your inboxes! I asked two things. 1. Care to share a preliminary solution / instructions? 2. Are you overnighting these because of the issues? ** snip ** "We have come to recognize that our new Bronco Hoist-A-Top is not 100% compatible with the 2 door Bronco. We are sorry for the...

That’s great news. Carter did respond to me when I sent him the pictures of the rear mounting plates not connecting properly. I did ask him for an ETA in my reply. Nothing yet.

Same tilt issue it seems ? - https://www.bronco6g.com/forum/threads/smarterhome-smart-garage-bronco-hoist.39239/post-1309701

I RX an email, snippet of email - Which came in before i was able to send them a note. * Snip * "It's come to our attention, with the help of another customer, That there are some dimension problems with the length of the Y shaped bar. We apologize for this inconvenience. We hope to come up...

Here are pictures of the bracket, one side will not allow the pin to be installed. I swapped the tubes to make sure that wasn't an issue. Made sure the tube going to the front was in the middle of the hardtop. Right Side: Left Side:

Im thinking it installs like the other lifts they have.