Search results

Well thinking about it I have spent about a little over 100,000 in reward point on Ford Accessories (Active Security system, and FR ARB Compressor). Everything else has been aftermarket accessories totaling over $3,000 (The top three being BD fog lights, Brandmotion Full Vue Mirror and of course...

The Keypad will do the same thing.

I followed the instructions. The bottom tap will only go in with the fuses facing up. The lip of the block interferes with them facing down.

I just taped it off. Like you said it is for the reverse features which is redundant on the Bronco since we already have a backup camera.

I would check the electrical connector for the visor. More than likely, it is not plugged it all the way.

I I taped the shroud for the door wiring and ran the new wires through it. I then ran it along the existing wiring I just attached it with electrical tape except for where it went into the door. I used a zip tie there. per the instructions I then routed it out through the vent behind the...

i just used the shop manual and snipping tool had to do something while it was raining.

I installed it myself. It is not that hard. If you can turn a wrench or Screwdriver, you can do it. You do have to remove the Curtain air bag tether strap. I went a bit further and removed the first bolt that secure the airbag so I could move it out of the way when I removed the a-pilar...

@craq5 See if this helps.

@Daktari it is different than looking through a regular mirror, but the camera has a 170-degree horizontal viewing angle so you see just about everything behind you.

@j_anderson they could add a second camera to the post. The beauty with the mirror is you can slide your finger up or down on the screen and the view you see on the screen will angle up or down as well without moving the camera's physical position.

@BulldogBuck yes there is a button on the bottom of the mirror that will turn off the display and it will function just like a regular mirror.

@fallguy I agree it should either be standard or at least and option. The reason I got it was because of the limited visibility out the back with the soft top down. @j_anderson I was thinking the same thing. The only issue I see putting it in or on the Third brake light is you would see the...

Mine did this in a heavy rain a couple of weeks ago. I need to take it to the dealer to get them to look at it.

It should only take about an hour / hour and Half. I did it over two days. I did the camera and mirror mounting in about 30 min on Sunday. I finished the wiring today I took my time since this was the first time, I had removed the A-pillar trim on the Bronco, and I did not want to break...

It has its own harness. and adds a camera to the rear. For me the hardest part was removing the trim panels to run the harness, but it was not as bad as I was expecting. FullVUE® Rear Camera Mirror for Ford Bronco FVMR-1120 - Brandmotion Here is a link to the install instructions...

Finished installling the Brandmotion Fullview rear view mirror I also installed Maybett’s glove box organizer and dash pads. I also bought his mudflaps, but I am on the fence about installing the mudflaps

I just finished installing the Brandmotion fullvue mirror FVMR-1120. The main reason I installed it was to help the rear visibility when the top is down. It was pretty straight forward install. The only part I was dreading was removing the a-pillar trim, but it was no trouble. it is a pretty...

I had a great time Today. Enjoyed meeting everyone and I can't wait to do it again.

First dirt. Took a ride in the North Ga mountains with the GA Broncos.