Search results

Thank you

This is what I used for the white ones. https://www.amazon.com/gp/product/B07CJLB446/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1 Don't use these white ones! Once they are clipped in you cannot get them out without breaking the panel. I need the detachable white clips. Need that Part # And...

actually, it is really easy. Can take apart in 5 min Use this video for assistance. I did when I installed the auto-start stop eliminator.

See attached

Center console right behind the charging pad.

I know these subject has been beaten to death. I have searched all the threads and cannot seem to find a direct replacement for just the rear panel factory B&O subwoofer. I understand it is a dual voice-coil 4", 8" shallow sub. Is this the sub here and has anyone just swapped out the sub and...

I agree. I have the Bronco Depot badges and they are great. Wanted to see what the OCDplug looked like and they are awful. Cheap laser cut where you can see all the cutting around the edge.

This is the mic holder that came with the Midland. Has double-sided foam on the back. Could always change the tape to ultra hold...

I tried to make the install clean where you can't see anything. Thanks! I am still trying to find a place for the mic as well! I don't want to drill into anything!

This is what I did. SWR is 1:21. Mounted my Midland in the front of the center console.

This one. https://www.amazon.com/gp/product/B09QM8W8Y7/ref=ppx_yo_dt_b_asin_title_o00_s00?ie=UTF8&psc=1

To get the antenna to clear, Did you use a wheel spacer?

I Installed mine here. Works great. Just shaved off the side of a 1/2" Marine board, used the super strond doubled sided foam tape. I also used 3M adhesion promoter. Tucked the power down the roll bar down and connected power to the "hardtop" ready plug us a +12v to USB converter. There was an...

Good to know. Thanks!

How hard was it to remove the plastic on the rollbar to run your wires down?

You can get ignition power from the mirror if you like. https://dongar.tech/products/16pin-ford-f150

This is what I did. Added three dashcams to the Bronco. Two in the rear(spare tire blocks the full view so have two) and one in the front. Used the Ford Dongar to power the one in the front and used powered the rear by trying into the "Hardtop" ready plug. There was an ACC power on that. Links...

Following.