Search results

No you cannot use the capable bumper d-rings look at post "791 in this thread. You well need a set of Roadmaster 35-1 adapters.

Are you getting serval brake warnings when you go into tow more?

When you go into tow mode you will get serval new warnings, also when you come out of tow mode you will get some new warnings.

I used a box and blocks on a small flat dolly to set the bumper on so not much lifting.

OBX with Modular Bumper, you have to remove the bumper and front skid plate. There are a couple of holes that have to be drilled. As I did not need the lower loops on the brackets I cut them off and did not have to cut the skid plate. Watch the clearness on the brackets when you put the...

The issue is the brake lights must be red and the turn signal can be either red or yellow. For the turn signal lights to be separate from the brake lights requires a 5 wire system. Almost all motorhome trailer plugs are setup for a 4 wire system were the brake and turn signal use the same...

Put one of these hitch tighteners on each receiver joint. You could be getting a lot play in your hitch setup...

What changed?

aknavy, look at Curt 58920 and Curt 58996. Check out this thread post# 775 https://www.bronco6g.com/forum/threads/flat-tow-equipment-needed-to-flat-tow-the-2021-bronco.19759/page-52

The Sasquatch package does not determine the front bumper. The Heavy Duty Modular Bumper is the only front bumper with D-Ring brackets suitable for towing (My Opinion), which is standard on the Raptor and option on some other models. There are serval threads about towing with the D-Ring...

M12 x 1.75 class 8.8 Zinc Plated 87.0 NM or 65.25 Foot pounds.

With the updated software (2.7 Tow Fix) the 2.7 no longer as active brake boost once you go into TOW MODE.

I put the wires in some split loom and ran it along with the factory wires from the rear.

Get a set of these, adds a little more light in the rear and takes care of the rear sensors...

You need a minimum of 1.1125" opening to fit on the Bronco shackle brackets ( they vary a little because they are a casting.) Best I can tell by scaling there drawing, the opening for the there adapter is ~ .86" which fits there bumpers which have a .75 shackle brackets.

Tilzbow used some short safety cables to get out to the front of his bumper. I installed a Eye bolt on each side using the outside crash bar hole.

A lot of people are using the roadmaster adapters (035-1), which normally fit without modication. As I have a Blue OX tow bar I use the Blue OX BX88357, these have to be opened up a bit to fit.

Rear glass is tempered not laminated.

Just wanted to know which RVI you had before I made a comment. You are definitely on the right track, enjoy and safe travels!!

Which RVI braking system do you have?