Search results

Hey from Murfreesboro. I've had my bronco for 3 1/2 months now. Purchased from Reddick Brown Ford in Morrison. Saw your sub install thread, looks sweet! I did the kicker hideaway mounted to the rear driver's side panel. Probably not as much thump as yours, but plenty for me. Also...

2.2" in the front, 1.2" for the back.

I did the RPG perch collar lift. Gives you 2.2" in the front and 1.2" in the rear. 37 BFG KM3's with 1.5" wheel spacers. Did the JKS max tire kit mostly to clean up the front with the aftermarket bumper. Zero rubbing at full lock. Probably would rub with enough articulation, haven't tested...

Yes, I have 1.5" wheel spacers. And no rubbing at all with turning the wheel full lock. Not sure about articulation. It's never been offroad 😅

RPG perch collar lift w/ 37 BFG KM3's

Installed RPG perch collar lift w/ 37 BFG KM3's.

I've been driving a 5.4 F-150 with straight pipes for the last 16 years. To me the cold starts sound very similar. Has a loud deep tone. Where they are different is once the rpms settle down to normal idle you can hardly hear the corsa. Driving you definitely notice it. Between 2000 and...

Installed the Corsa turn down this weekend. Here's a view and sound clip of it. Sorry the video is poor resolution, still learning how to post them.

Installed the Corsa exhaust with turn down tip. Sorry for the poor resolution. Still learning how to post videos. Cold start. Some revs.

They are the drive beam, with white backlight

Thanks! I have 1.5" spacers on factory sasquatch wheels. Don't have any pics of the poke. But, here's a side view of the whole truck.

I have 6" rigid 360 lights sitting on top of the ADD winch bumper.

I didn't have to tap into the speakers. The harness from plug and play does all this. On the kicker key amp I set the high pass crossover to 80. And the kicker hideaway I set the low pass to about 80 also. I didn't have to tap into the speakers. The harness from plug and play does all...

The install was fairly easy. I bought the kicker hideaway and wiring harness from plug and play. Everything just plugged in, and I had to run a hot wire to the battery, and a ground wire to a ground screw behind rear panel. The hardest part is taking off the rear panel to run the wires...

I used the srews that came with the sub, and screwed it right to the plastic rear panel. I did put a layer of sound deadening material between the sub and panel.

This guy did a test and went 40 miles after 0 before he ran out completely

Was able to turn the sensors so they're atleast looking back at me, instead of up in the air. Took a night shot of the backup camera with the lights on.

There's a bracket attached to the spare tire carrier for the license plate. Seems pretty solid. Has rubber bumpers behind it to keep it from scratching the paint. Yes, the sensors are angled up on the factory bumper. Instructions say to install them the same way, pointing up, to avoid...

Rockfighter winch bumper