Search results

the last 2 digits are the checksum: 760-03-01: 3480-004C-DF4A changing the 3-> F would mean it should be: 760-03-01: F480-004C-DF0A

I can shoot that over to you later tonight ( forscan changes if you want.

Clearly the first digit shown is a three, is that before or after you changed it?. Also, do you have a 2.3L engine?

What did you have before. What specific changes did you make? (All changes) What were are you looking to do? ( For clarification)

The module TRM, Trailer Relay Module has different firmware. The settings are different. As well as settings relay to the IPC ( as it being full digital)

Is it a 4-pin that you have? That green wire. Can you tell me that picture location, can't tell from the picture? Terrible guess. It is someone's ground wire (chassis ground)

You have a tow(4 pin?) by any chance?

If you have only five lines I have a strong assumption that is a TRM module for a bronco sport. You have a whole bunch of errors because that's not the correct trm module. Do you have the model number for what you put in?

You can just rewrite the values listed on the first post

Just for accuracy, the bronco does have lane keeping. (Or can) It does not have Lane centering, or intelligent cruise control. I don't believe anyone has had traffic sign recognition working. I understand there's mythos of someone prior said they have it. I've seen no proof of this. I would...

Question: Did you ever update your ProCal after your initial install of the tune? If so, at one point there was a bad update that was pushed by Ford performance that corrupted the unit. Send an email, they may call you back relatively quickly. They can correct The issue with the ProCo if you...

Just for clarification, the tow module for the 2025+(TRM trailer relay module) is different. It has a different firmware that cannot be (at least currently) forscaned away.

Again, just because the setting is shown in forscan, does not mean that the IPC has the firmware to display or the ABS module to do that. More likely than not. There's literally no display animation programmed into the instrument control panel to show you that mode. The ABS doesn't have the...

Non-Raptor versions of the bronco do not have a tow Haul mode. Those settings can be seen in forscan. That does not mean the firmware related those modules will allow that.

What part specific part number(s) get you get. You're describing installing a curt controller and saying that to the programming could see the module. In order for anyone to give any input or advice, information pertaining to products used is necessary. And How these products are connected...

No, my point is double check the wiring connections at both sides of the rear bumper. That's why (strongly educated guess here) the connector for the rear parking sensors in the bumper is not fully seated. They are extremely hard to push back together. I actually used a small pair of...

Did you install a hitch/receiver around the same time?

Your original lighting wasn't LED, correct? When you added aftermarket lights, did you change any programming, for them to be LED? I guess my point would be. I believe your original lights were the halogen. Your bronco believes you still have the halogen lights. You bought aftermarket...

You have a Cause (air compressor) You have a Result dead battery / battery drain. What you have not indicated is any diagnoses of the how this is happening. Have you disconnected all wiring to compressor (including aux wring) Have you ohmed out the wires? Check the continuity. Verified there is...

See how item (1) has like 40 square holes Item(15) has about 40 plastic arrow tabs that go into the item (1). The picture you sent of the broken piece , that is part of item (15)