Search results

what is the part number for the switch that you used I am wanting to order one and didn't want to read 50 some pages thanks

looks good mine is holding up well the flares are taking some rocks even with the mudflaps on seems to be sticking where the chips are though

aluminium fender steel flare not a fan

I wanted a quality undercoating gun and the wool wax had great reviews and I was very pleased with the results I know it works better than the spray cans and get more product for the money there are other guns out there that are cheaper and more expensive but overall this worked great for me

I think it was around 180$ for everything but you could probably do your truck 3 times. Also the wool wax gun came with 1 quart of wool wax spray bought everything on Amazon for me the cost made more since because I will keep my bronco for a long time and will reapply this product

I bought a gallon of surface shield and sprayed it through a wool wax gun works great and used the 360 nozzle throughout the frame and all the body panels

mine does

well i see they are still sending out mismatched tops also

yes holding up but the rear flares are still getting chips even with the front mudflaps but no delamination seems to be sticking well

ppg sealer ecs series

i did it putting the door on no i did not damage the door was just asking if someone makes something to go there to protect the pillar and to keep from beating the door edge up

yes i must have bumped it with the back door

center lower pillar put a dent in mine puting the door back on i am careful sure others have done it.

i have a 2021 first edition that was on dirt mountain and had to have the battery replaced last month it died at the carwash then a few weeks later i pulled it outside and it was dead a few hours later also i had just unhooked it from a battery tender the second time

any updates on this issue mine is doing the same thing

windows were pretty tight around the edges was just careful with a window tool and used a window knife on the inside once we got the sides and bottom loose thought I cracked one at one point don't know if they are available yet I did scratch the top getting them out but I am not a experienced...

yes aeroskin 2 from the ford accessories

on the flares I used a red pad and 600 grit and sanded the crap out of them cleaned with wax and grease remover used a ppg scuffing sponge then used a ppg adhesive wipe then applied bulldog adhesion promoter then I sealed them with about 4 coats of heavy sealer I think the sealer may have better...

all ppg products on top also basecoat is water-based and yes these are the textured now smooth SAS flares

I blocked the entire surface with 150grit then primed then 150 blocked and 220 blocked then primed again then blocked with 320 and da with 400 and yes I blocked the most of the surface flat I used ppg 3055 primer