Search results

Visual inspection looks normal. No leaks.

Thanks! Did the measurements from there. I’m within spec. Though I’m nearly empty. I’ll check again when I get a tank of gas.

I have a Sasquatch bronco with the 2.7 v6. I’m wondering if anyone have measured both front fender height on their Bronco? I was looking at doing a leveling kit as the next mod and noticed that my driver side front is 1/2 inch lower than the passenger side? The rears matches though…which is odd.

Just got my RCI ski plates in today and installed it. It was straightforward and easy.

Saturday sounds good

Looks great. Wish I knew how to weld.

Details on the switch bracket? I mounted my apex winch but haven’t found a good way to mount the switch. Yours looks good.

@robepa @SnowBronco @BillyGoat @CashOfLegend Just found the weights on their site. It’s listed for individual pieces. Front Bash Plate Steel- 40lbs Aluminum- 25lbs Transmission skid Steel - 35lbs Aluminum - 18lbs transfer case skid Steel - 30lbs Aluminum - 15lbs Whole set: Steel - 105lbs...

I noticed today that they do sell individual pieces now. https://rcimetalworks.com/product-category/ford/bronco/2021-2022-bronco/

@RCI Offroad curious on weight of steel vs aluminum option as well.

@ASFIR 4x4 has skids made for the plastic bumper. https://www.asfir.com/manufacturer/pvrd/bronco.html?car_manufacturer=7977&car_model=12598&car_year=12599

beach season!

Buy lots of fireworks and light it up!

looks like they have 15% off right now for the fourth.

Link https://rcimetalworks.com/product/skid-plate-package-21-bronco/

does it look like the Asfir cross member protection will fit with the ARB skids?

It’s actually 1.5 inches

Here’s a pic of the bezel that I masked off before cutting and the reference mark if this helps anyone. for the radius mentioned in the manual, I didn’t cut into the corner all the way to allow a break off area. Then I went through with a rotating sanding bit to create the radius. pic after...

Thank you

Did you use a routing bit or spinning disc to cut? I’m about to do mine..