Search results

I agree with some here the logo on the back ruins it for me. If the OEM version now has that I’m out.

Same here.

I would love a front seat set of these!! 4door version would be even better.

Found this th read by accident. When my doors were off I was getting the crazy messages about the hill start, brake blah blah. It seemed to be tied with the amount the brake pedal was depressed? It seemed to do it when I barely pushed down the brake pedal. If I shut the truck down and then...

Got it. The window is hood no looseness. Checked the window tonight and the hinges are tight at all the connections.

I will double check my hinges but I did not notice any.

Thanks for the silicone spray tip I will try that. Temporary solution but at least it will hoepfully help identify the specific sea/areal that is most noisy if that is where it’s coming from.

Anyone have a vibration/rattle noise over bumps? I've identified mine as the rear hatch glass. I tested it by opening the glass and driving around and voila gone. I'm thinking it might be the rear glass rubbing back and forth on the two bumper rests at the bottom? Or it's the entire glass...

🤔

Hazard - that last one helps a lot!! I should be good! Thank you. Now to save my money for the gearlockers.

So for my setup with the Sasquatch spare I would probably need a slightly longer extension.

Thank you Hazrad! So if I’m reading correctly the dual gear locker setup is going to make contact with the Sasquatch spare with the Yakima straight shot 7” extension? I think I got all of that.

Do you mind sharing the part number? Thanks!

For sale OEM mudflaps front and rear. Never installed on my Badlands w/Squatch because I was never brave enough to try and modify them to make them work. I finally got another brand and do not need these. I did open the bags to eyeball but never even tried to install. $80 OBO buyer pays...

I know this I an older thread on the EXO system but for those that have it do you think the setup with dual gear locker boxes would hit the spare using the standard

Thank you the update! I’ll stay tuned!

I didn’t realize there was a non gap version coming but the notch will likely allow some rocks to come through but if you bought these to work with the running boards I should be fine. If I had the rock rails back on it would likely be fine but I may switch these out when the non-notch version...

Same here. You would need to cut the fender liner to make the supplied bracket go behind the liner.

Is there an update available on the neoprene seat covers? Thanks!

Mine are getting delivered today and I will be putting them on immediately!