Search results

Thanks! I was hoping there was a cheap mattress that went the whole length etc.

Thanks all. Any air mattress reccomendstions for a 2-door once seats removed

I’d like to take my Bronco to the drive in and put a mattress thing in the back, by folding the seats won’t work. Can I easily remove them?

Yes that is what I’m talking about. What is the purpose? Can you keep it on with the hard or soft top?

I see a lot of jeeps with roll cage fabric wraps. Was curious what the purpose is. Do you leave them on with the hard or soft top installed? guessing it’s to protect the paint when removing/putting on the top? do they make these for the bronco?

Finally finished!!!! Garage ceiling work done and hoist installed.

I guess I can see if the OEM antenna contacts the hoisted top. In all reality I only need the antenna to be 5-6 inches shorter….doesnt need to be a stubby…

Thanks! Does the passenger windshield wiper clear it?

Due to the hardtop set up that I have which will be stored above my vehicle, the current OEM antenna will contact the top. I know it’s minimal, but I don’t want the hard top to sway while hoisted up. To do this I would need to get a shorter antenna. Are any stubby antennas actually work as...

Anyone else experienced on start up a frozen infotainment screen? put vehicle into reverse - camera engaged - putting back into D and the screen is frozen on the rear camera view but not moving - so frozen. it’s intermittent.

I have this and solved the problem. It was caused by the rubber seal rubbing against the back of the tailgate. I put some rubber seal conditioner (gunnipledge) on the rubber - sound gone.

Also - does the motor shut off when it’s too hot? It’s not longer working. I’ve been raising and lowering it a TON trying to level it and then it quit. ..

Ok I installed this today following the instructions. Ceiling mount. I literally can t get this thing to stay consistently level. I’ll have it perfect then a few raises and lowers and it’s badly off again. It just have to do with how the cable is winding around the drum. If it doesn’t...

For those who have installed the Lange hoist for the 2-door what was the difference needed in “slack” between the front eye hook and the rear. I know I’ll have to do some trial and error to get it level but a rough estimate would help start things. For example is the rear hook 6 inches more...

Oh I’m aware. But I’ve only removed that one panel during the sub install , after which the message started. No other panels were touched. I’ve read disconnected PATS can cause the key not detected message but unless some other random non touched PATS came loose 🤷🏻‍♂️

Well using my snake camera my PATS antenna looks connected to me…. So the source of the Key Not Detected continues …

Well that explains why I can’t see it. It’s deeper in that I was hoping to remove. I’m gonna get my snake camera…

I’m checking to see if I have a loose rear panel PATS connection and am seeing if I can tell without ripping off the whole panel again. I cant tell if what I’m seeing if the antenna. I see a yellow plastic plug that appears to be connected but am not sure I’m looking at the right thing. The...

Same issue. Also removed rear panel. So 99.9% sure the above is the issue. However cannot figure out why it would only happen once every few months if that’s the case….

Can anyone point me to a photo of this antenna wire? I’m gonna check mine…just got this message again after not having seen it for 2 months then after I saw it and used the center console passive start it works now with no message. 🤷🏻‍♂️