aFe Sway-A-Way Coilovers - Now Available at Panda Motorworks!

[Panda Motorworks]

We’re excited to start offering the aFe Sway-A-Way 2.5 Front and Rear Remote Reservoir Coilover Kit for the 2021–2026 Ford Bronco here at Panda Motorworks.

These coilovers are designed specifically for the 6th-generation Bronco and offer adjustable ride height, application-specific damping, increased wheel travel, and 16-position compression adjustment in a direct-fit package.



2.5" Remote Reservoir Coilovers

The Sway-A-Way kit uses 2.5-inch front and rear coilovers with remote reservoirs. The system is designed around the Bronco's factory front and rear control arms and provides up to 10.5 inches of front wheel travel and 11.5 inches of rear wheel travel without binding the suspension or overextending the brake lines.

The kit comes preset for approximately 2 inches of lift, but the ride height can be adjusted from 1 to 3 inches of lift using the included spanner wrench.

If the lift height is adjusted beyond 2 inches, a track bar relocation bracket is recommended.

16-Position Compression Adjustment

One of the main features of this setup is the integrated mid-speed compression adjusters on the remote reservoirs.

There are 16 clicks of compression adjustment, allowing the damping force to be increased by up to 200%. This gives you the ability to adjust the suspension based on different loads, terrain, and driving conditions.

The compression adjustment changes compression damping without affecting the rebound damping.

Dual-Rate Springs

The coilovers use dual-rate coil springs designed to provide a comfortable ride during everyday driving while offering additional support for off-road driving and increased vehicle loads.

Combined with application-specific valving, the system is designed to provide a balance between ride comfort and suspension control across different types of terrain.

Construction & Serviceability

Sway-A-Way coilovers are designed and built in the USA and use a number of components intended for long-term use and serviceability.
Some of the construction features include:

• High-strength steel cylinders
• 7/8-inch polished Nitro Steel shafts
• Fully synthetic 7wt shock oil
• Redundant multi-seal carriers
• Viton O-rings
• CNC-machined aluminum components
• Completely rebuildable shocks
• Revalveable shock design

Being rebuildable and revalveable also means the shocks can be serviced and adjusted as needed over their lifespan.

Direct-Fit Installation

The kit is designed as a direct-fit installation and does not require vehicle modifications.

For Broncos running more than 2 inches of lift, a track bar relocation bracket is recommended to accommodate the increased ride height.



Key Features

• 2.5-inch front and rear remote reservoir coilovers
• 16-position compression adjustment
• Up to 200% increase in damping force
• Dual-rate coil springs
• Up to 10.5 inches of front wheel travel
• Up to 11.5 inches of rear wheel travel
• Adjustable from 1–3 inches of lift
• Preset to approximately 2 inches of lift
• Application-specific damping
• 7/8-inch polished Nitro Steel shafts
• Fully synthetic 7wt shock oil
• Multi-seal carrier with Viton O-rings
• Completely rebuildable and revalveable
• Direct-fit installation with no vehicle modifications
• Designed and built in the USA

If you're looking to upgrade the suspension on your 2021–2026 Bronco, these are now available through Panda Motorworks.

Check them out and reach out to us if you have any questions about the setup or fitment for your Bronco!

SHOP NOW

Sponsored