Bronco Grill Lights by F150 LEDs

[MGG15]

Installed 3 grille lights by F150 LEDs. First time installing anything electrical. The plug and play headlight accessory made it easy. Instead of reaching the back of the headlight assembly through the wheel well liner, I removed the grille, thin front trim piece & headlight. I found this to be easier as I tried to go being the wheel but couldn’t reach or see anything.

Does anything think I should have spaced the lights out one slot further?

Links:
https://www.f150leds.com/collection...ronco-plug-play-headlight-accessory-connector

https://www.f150leds.com/collection...onco-raptor-style-extreme-amber-led-grill-kit

Sponsored

 

[Fordsoldier]

I think with 3 spaces in between them looks good. But I dont have them in my grill. Been on the fence about adding them.

 

[HighVelocity]

You should have put a light in every slot.

 

[glashaus]

You should have put a light in every slot.

I almost did

 

[DarthLincoln]

For reference:

 

[broadicustomworks]

1. Yes, The ends in the 3rd slot from the end, center 3 slots each side between it and the ends.
2. I'm distracted by the depth and cleanliness of that garage/workspace/place you'd see a DB4 sitting alongside an AC Cobra, just in front of a RUF Yellowbird.

 

[MGG15]

For reference:

[/QUOTE]
Do you have a picture for reference of how this would look? I’m concerned that the adhesive is going to stay where it is. Not sure I can adjust them antmo

 

[adamruiz2001]

I think with 3 spaces in between them looks good. But I dont have them in my grill. Been on the fence about adding them.

This one isn't mine, but I did the 2 spaces in between on my Bronco like the pic below...

 

[Fordsoldier]

This isnt mine but this is on a wildtrak with 3 spaces. So now you have a reference for both 2 spaces and 3

 

[MGG15]

Anyone know how I could remove them and put them in the other slots without damaging anything?

 

[adamruiz2001]

Anyone know how I could remove them and put them in the other slots without damaging anything?

Simply uninstall two lights and reinstall into a different slot. I wouldn't think it's that difficult. Not sure how these ones are installed, but I would assume pretty simple to remove and replace if needed.

 

[Fordsoldier]

I did chat gbt photo of mine and had it put lights in my grill.

Still on the fence

 

[MGG15]

Simply uninstall two lights and reinstall into a different slot. I wouldn't think it's that difficult. Not sure how these ones are installed, but I would assume pretty simple to remove and replace if needed.

They are stuck on with an adhesive so not sure how it’ll re apply. I bought .5 inch think 3m adhesive to use to reapply. Hopefully it sticks.

 

[adamruiz2001]

They are stuck on with an adhesive so not sure how it’ll re apply. I bought .5 inch think 3m adhesive to use to reapply. Hopefully it sticks.

Oh wow, I didn't know that, well, now I know lol.

Yeah, more than likely, like you said, you will have to reapply a 3M trim panel adhesive backing to the removed lights to install in a new slot location. Then you will have to clean the old adhesive that may have stayed behind on the grille from the frist install location. Time consuming, but at least you will get the look you are shooting for.

 

[adamruiz2001]

I did chat gbt photo of mine and had it put lights in my grill.

Still on the fence

Sponsored