Recent content by TLO

This is already how my non-sig lighting works on my Big Bend 🤷🏻 Front ambers are on all the time

Just checked my 2026 Big Bend 2.3 VIN. In the clear...but the infotainment screen is listed (and I have a letter from Ford) Says the recall is still open but I remember getting an OTA update for this. I don't have to take it in do I?

Some of you are familiar with my lonely overlander channel... And in all honesty, I've never done a full build walk around... Until now. Introducing my 2026 four door, Big Bend with Squatch and Black Diamond pack... Enjoy

Mine is different....

I was just looking at the OG Ford Accessories tailgate table... Can anyone confirm or deny compatibility?

Bump... Any updates?

I dig your Roam setup. I have a single Pelican 55L and their quick rack mount. Going that cargo route is definitely an investment! Thanks for sharing

With the new 4 door build coming along, I've needed to reconfigure (and improve) my load-out... I'm thinking about moving the traction boards up top... But I have an awning on once side and the RTT opens to the other. How do you have yours setup? Thanks the lonely overlander

I have a playlist of the entire trip... The last 2 episodes are the 'event' and the recovery. I still don't know how it actually came off the bridge...having 2 wheels off shouldn't have ended this way.

Really?? I think I win this one....

Thanks...vid not much help. But I managed to get it all together I'm actually using it to power a multi USB charging port. I have a DV8 overhead Molle panel and mount my Sony camera, drone and laptop up there so I can charge while on the go 👍🏻 The circuit is good for 10A (AUX 3) but you can...

Have you ever tried sheep skin? Probably the most comfortable seating solution there is. (No, it won't make it hotter). I've used just a scrap piece before, from an upholsterer. You should be able to find one for much less than $200. You can have a look at a custom fitting one that a friend made...

Welp, found it... Wrapped up in hockey tape with a half inch of wire expose, in the A-frame corner, and facing the outside of the Bronco 🤬 After pulling the shrink cap and yanking it out of the tape, here is what I had to work with.... It's not that the wire wasn't long enough, but shifted to...

2026 Bronco... I have the entire windshield brow trim pulled down on the passenger side. I can see the taped up harness running across to the center aux switch panel... But I do not see the AUX wire lead anywhere up there... Anyone help out?

I've been misinformed again! Thanks...