Sponsored

Recent content by rtd16

  1. Thumping Noise in 4WD

    Thanks Silver-Bolt. Since that post I had the axle changed out, and the problem persisted. I believe this is more of an issue with the differential than with the axle itself. Ford apparently opened a "case" about six months ago on it, but I've never heard anything from them. Dealer would only...
  2. Another Broken Axle / CV Joint

    Sorry to hear that. And see it on a flat bedšŸ˜–I’m interested in how Ford handles your situation
  3. Burning oil smell after drives?

    Did you ever confirm anything with this or did it stop? I too have an oil smell, particularly at idle or stop and go traffic. I’m assuming it’s the catch can but don’t know if there’s a solution. I checked all the hose connections and the catch can is growled down like an SOB….
  4. Need help checking cv angle

    Thanks V1Rotate. The noise is a cyclic clicking or thumping only in 4WD when the front axle is being driven. I replaced the axle already but still have it, so I'm not sure if it's just the shaft/CV angle (my Eibach set was installed by a shop at 'factory' setting, so maybe it is at the top of...
  5. Need help checking cv angle

    If you are really concerned I would recommend picking up an inclinometer and checking the actual angle. No offense to V1Rotate but it's tough to get an accurate measurement using a picture as there's a lot of variation into setting that baseline based on the picture (I tried that initially with...
  6. Water in Catch Can

    Thanks. Just seemed like an awful lot of water even though some condensation forms in the crankcase
  7. Water in Catch Can

    Not really, my drive to work is about 30 minutes and I don’t do many short trips in between. Thanks
  8. Water in Catch Can

    The photos show what I found in my catch can today changing the oil. Last two oil changes there was only about 1/8 to 1/4" of actual oil in the bottom of the can. This time as you can see it was about 2/3 full with fluid, seemed like water (thought I smelled fuel but I think it is going to...
  9. Another Broken Axle / CV Joint

    Well, there currently isn't one. I took it to the dealer initially who said it was the axle due to the lift, and wasn't covered. They recommended replacing the axle, but I didn't want to use them because I haven't had good luck with them in the past. I ordered the axle and had it replaced...
  10. Another Broken Axle / CV Joint

    Yeah, unfortunately money to upgrade wit the problem:ROFLMAO:Those upgraded axles are around $2K
  11. Another Broken Axle / CV Joint

    Unfortunately no. So I'm sort of stuck dealing with this unless Ford discovers some sort of recall-type issue with the suspension or differential. I've read few here and there about surprise differential failures (even without modifications), but I don't know there's been enough occurrence to...
  12. Another Broken Axle / CV Joint

    While I agree, Ford does advertise it can be lifted on the non-Sas models (and the 'lift me baby' messaging on the fenderwells), I do believe there is something else going on here. From personal experience after putting the Eibach lift on (non-spacer), I have thumping/clicking from either the...
  13. Axle Replacement After Lift Install ?

    Thanks. I have the adjustable EIbach coils springs on mine, so an option is to get out there and lower the lift. I measured the driver's side axle shaft angle at about 17 degrees (with vehicle on the ground) and passenger side at around 11, I believe. I also found elsewhere on here there are...
  14. Dana M190 AdvanTEK Front Differential Problems (non-SAS) - Clicking Issues

    Are all of your noise issues in 2WD? I've posted elsewhere I have a clicking noise from the front as well but only in 4WD. Replaced the front axle shaft due to suspecting the CV joint but didn't fix the issue.
  15. Axle Replacement After Lift Install ?

    Well that was short lived. Although noise seemed to be gone immediately after the axle replacement, I had it in 4HI on snow covered roads driving to work (actually the "slippery" GOAT mode) and the repetitive clicking/thumping sounds is back. So not sure if it's just the angle of the axle shaft...


Top