Recent content by Max1h

I guess that all depends if you want to keep the factory setting and goat modes etc. I never use those so I’m fine losing all the fancy stuff toss in an atlas and call it a day :) this thing will just be a bronco shell at some point lol

Haha I’ll just go rip a used one out of an f250 much cheaper :)

Sure can! Just built a tube frame bolted into the bronco where the tie down brackets are, used wood in the center, put the fridge slider on another pc of wood. Used a piano hinge because that’s all I had on short notice ha but it works, and I use a limiting strap on the other side to limit how...

Nope no need does great :) when the 2.7 goes ill prolly toss is the 7.3

Will have to see what he comes up with :)

I've been slowly building this Bronco over the past couple of years, changing and upgrading parts as I've learned what works best on the trail. It started as a stock 2023 Badlands Sasquatch and has evolved into a dedicated rock crawler that's still driven to and from the trails. It's seen...

Who did you order through? I went through Wild Horse and had both in less then a week but that was like 6 months ago :)

2023 Bronco Badlands (formerly Sasquatch... none of the Sasquatch parts are left 😂) I wheel it hard and seem to find a way to break something every month. 🤣 Currently running Nitto Trail Grapplers 37x12.50R17s on Ford Performance beadlocks, with a Dana 44 Ultimate front, Dana 60 Ultimate...

Mounted my ARB to a molle in the same spot, Its on the inside now cuz im redoing the entire rear section so dont mind the hose lol its just there so its not hanging down :)

Vashers Designs has you covered :)

Your Ford Bronco Badlands Sasquatch isn’t a commuter — it’s a rolling midlife engineering crisis with beadlocks. You built this thing like you personally expect the apocalypse to begin somewhere between Sand Hollow State Park and the Taco Bell drive-thru. The Bronco has: Fox 3.0 coilovers...

Prolly only 15k the bushing said nope lol

watch the bushing on the upper with zone. Mine didnt last to long. Just replaced them with Foutz uppers. I was 3 inch lift with fox 3.0 race coils, zone uppers, JKS max clearance. I do wheel mine pretty decent though.

Flew out to granger IA and drove it back to Utah :)

I’m on 37s, Speed limit up here is 80 and I’m around 2500/2600 , digging out a broken body mount bolt if you’d like once its running again ill see what I’m at around 65mph , average mpg is like 11.5/12 lol I’m also on beadlocks at 30lbs tops so that plays a small factor sorry for the late...