Recent content by Jeff587

I used a step up drill bit from harbor freight. Just kept going until the hole was big enough. One size at a time.

They put the wrong fuel in the wrong tank in the ground

Yes! You are right. 60 miles later i have a check engine light, catalytic converter efficiency below an acceptable level

Here we go. 60 miles later i got a check engine light. Catalytic converter efficiency code. Seems like i need new cats.

Back on the road. Fuel tank was emptied. New fuel was added, oil was changed, spark plugs were changed and fuel rails were flushed five times until all the diesel was out. Drove it about 45 miles so far. No problems. Ill post another update after i drop the bill off at the gas station...

It has park sensors relocated

Yes they pump it. I think i would have noticed if i was pumping

Seemed like they had a few others before me. I didn’t know what the problem was until the ford dealer diagnosed it. It was almost 24 hours later until i got an update from ford and went to the gas station. They were very cooperative.

Hey guys, unfortunately I stopped for fuel on Sunday and had my Bronco filled up with super unleaded. (full service station) Unknown to anyone there was a mix up when the fuel was delivered and the delivery guy put diesel in the underground tank. I only made it a half mile up the road when i...

I dont think it needs to be done. Im sure they dont react the same as if they were 10” back on the bumper.

Badlands Sasquatch Lux with factory/Warn winch set up. Successfuly relocated inner park sensors to winch plate It took 5-6 hours labor over the weekend only because i was unfamiliar with everything. No more turning off front park sensors every time i start the Bronco

In the process of doing it now.

My Ford dealer said they could not reconfigure RCM but assured me the settings on the airbags will work as intended if activated. I cannot confirm this but it would be a huge liability if they were wrong.

Not yet. The ACC works fine. Just need to move the park sensors out