Recent content by Dan-O

Unfortunately that’s the same boat many have found themselves in. I’ve already had my top replaced and as most with a MIC, concerned about warranty expiration. Choices are to live with it, buy a new top(OEM or aftermarket) or have cracking top linex’ed. It’s a real shame Ford is letting all of...

Should have power, that’s the 7 pin connector. The cover on connector shows wiring diagram of pins. Think it’s like the 7 & 1 o’clock positions. The black and white wires are 12v and ground. EDIT…. Oops, just looked on mine, it’s the 4 & 10 o’clock positions

Bummer….Maybe they sent ones for Bronco Sport. They definitely do not look like they fit especially the rear. Man I seriously hope they sent wrong vehicle otherwise those are way off!!!😂

Oh ok, a few posts on here about that too. I think people were finding that the tank wasn’t venting properly and that’s what was causing that problem and their fix for that was drilling a small hole, I can’t recall, if it was drilled in cap or neck just below cap. Try doing a search on here for...

Quite a few posts on here about people having same problem, including me. It’s about 50/50 the tank has a crack where the 2 halves of plastic are welded together or the other problem if I remember right was a I think the seal where the pump plugs into bottom side of reservoir. Need to pull flare...

THIS

Water intrusion to the interior is not normal. With that being said, there has been a few Bronco owners that have had a similar problem. I know at one time there was some kind of Ford fix with sealant on the passenger side header seal.

That’s definitely not right. If your vehicle came with the MTs, they should have put MTs on the 2 you bought. If for some reason they couldn’t get the MTs they should have let you know and gave you the choice. I would for sure be talking to service manager and or General manager.

My opinion, I don’t think you would see a difference in paint, especially on that color. I highly doubt it looks any different underneath. As Smocaine stated, there could be some scuffing under but I doubt it, that tape adds a bit of clearance, if it is a bit scuffed a quick polishing compound...

Past 2dr MIC top and my 4dr MIC both had/have the same alignment look. As PWillette stated, I too think that looks pretty normal. Unless you’re getting water intrusion or excessive wind I think it’s pretty normal. Not sure if MIC/Painted align the same or not though.

I checked on mine…..I was wrong, you’re right, I apologize! That feature is on my other vehicle. I’m pretty sure the module needs to be programmed by dealer with the new camera. Hope they get you taken care of quickly.

I’ll check it out tomorrow because I turned mine off at one time and they were gone, then got them back. Hope I’m not getting my vehicles confused…New tailgate, new spare carrier with camera I’m assuming.. I think the new cameras require the camera module to be programmed?????

There is actually a setting on or off in Settings. Hopefully that’s all it is.

Not positive……but I seem to remember that being asked her before and if memory serves me correctly, it was said those points are used during assembly. Hope I’m not mistaken😬 EDIT::::: As usual Ducati beat me to it

If so, it’s definitely the right thing Ford should do.