Search results

The 1st part of the install has some electrical tape like material that you put down on the ledge that the hard top sits on. I'd just buy some 2" electrical tape to replicate. It stays in place with either top. The other foam they provided was not very dense and I remember that I replaced...

Bought a simple cord (phone jack to open wire) and getting 12 v from the camera module wiring. Used a tap to get to +12 (switched) and Gnd wires. Googled the pinout of the harness. Link to cable - https://www.amazon.com/dp/B097MGX318

Like to see a link to your video when you upload it…

This Pix looks complete for the 2 door top. The plastic bits are needed!

2 door or 4 door?

I am able to install/uninstall by myself on the 2 door. A bit awkward at times, but doable by 1 person...

No, that can stay.

Would love to get my back side windows to open like in a minivan... (I grew up in the Fort!)

Going back and forth between the soft top and hardtop is definitely a process. I ended up rewatching the installation video each time I swapped. Took a couple of hours each time, and yes several parts come off when going from soft top to hardtop. Had the mic top on my 1st bronco that got...

That stuff is quite expensive. Just finished my back end rear seat delete with simple 3/4" wood & glued on carpet combo. Tons of low cost storage containers at Lowes / Home Depot for storing / moving stuff.

Had been meaning to post Q if anyone had tried to install the below. There are options to only purchase the display as well...(much cheaper that way)...