Sound deadened rear cargo area and all four doors. Somewhat tedious work but definitely made an impact on sound. I'm averaging 64db at 60mph now and was well above 70db without.
Did the pipe insulation hack to quiet the wind noise. Used two 6foot sections of 3/4 rubber pipe insulation on the sides and cut some smaller pieces to put in the gap under the front of the hardtop. This actually has made a significant difference in quieting wind noise.
Took Blucifer up to the Sawmill Gulch Loop off the Switzerland Trail North in Boulder. It was a good test of Starlink mounted to my roof rack. The mount held solid with all the bumps and climbing.
Added the JCR Offroad Bronco Short Roof Rack. Assembly and install was pretty easy except when mounting on the roof with the brackets. Took a lot of grip strength to get the screws to mate with the bolts.
Took it up the Deer Creek Trail in Colorado towards (but not on) Radical Hill. Stopped at the top of Teller Mountain, ate lunch, then went back down the same way we came.
Hi All,
I'm looking to add a half rack for my 24 Badlands and I have seen posts about both of these. Are there any positives/negatives to each (construction quality, noise, etc)? I'm leaning towards the JCR mostly because it is a bit cheaper and the Trailrax half rack is sold out unless I...
Disconnected the battery for a few hours to reset the TCM. The Bronco always had rough shifts especially in the lower gears (even with the protune). This appears to have mostly resolved it. It feels much smoother driving it after.
Installed Baja Designs Dual Fog Light Kit w/KR Off-Road Bracket. 1 set of Amber S2 SAE and 1 set of white S2 SAE. Another pretty easy install thanks to the harness from 4x4 Truck LEDs. Although I did cut the butt splice connector off and did a lineman splice with solder and heat shrink...
Installed the ARB Twin Compressor w/KR Off-road mount and KR Off-Road Air Coupler Switch Bracket from 4x4TruckLeds. Took a bit to get it right but everything went in and connected well. I'm super happy with how it came out. I have the upfitter switches but used the ARB switch instead since i...
I have a 24 that was built in October and I bought it Jan. The keypad was the first accessory I had installed. Works great with no issues and I use it quite a bit