Sponsored

Search results

  1. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    I looked at going that route but didn't want to complicate changing a flat tire. The wife uses this as her daily driver. If it was me...I wouldn't care to have to move the lights to get to the spare.
  2. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    Texas doesn't have a rear ID requirement...even for a commercial vehicle 80" or wider. Transportation code here says they "may be equipped" but doesn't say they are required.
  3. Official: Ford Performance Tune Released for Bronco Raptor for 455 HP / 536 LB-FT Torque [UPDATED]

    Okay this is going to be lengthy so brace yourself....this is for those of you who are not sure your tune took when you tried to flash your PCM. This is my personal experience and nothing below is Ford Performance backed information. I had my suspicions my tune did not upload correctly when I...
  4. Mounting Sasquatch-Size Wheel/Tire Assemblies . . .

    The guys who fix flats for our 18 wheelers use 3' long crowbars to get heavy wheels/tires back on the vehicle. They put the wheel as close to the studs as possible then use the crowbar to lift the tire up from below. The flatter angled end is perfect for getting a 1-2" lift off the ground. After...
  5. Official: Ford Performance Tune Released for Bronco Raptor for 455 HP / 536 LB-FT Torque [UPDATED]

    Hmm Ours will overpower the brake pedal and lurch the vehicle forward still. Might run the Procal again tomorrow and re upload the tune.
  6. Official: Ford Performance Tune Released for Bronco Raptor for 455 HP / 536 LB-FT Torque [UPDATED]

    How significant are we talking? Didn’t own ours long enough to play and notice downshifts in sport mode. When rolling to a stop, light on the brake, our Raptor still burps the exhaust and kinda lurches you forward. I did a WOT roll out from like 10MPH and was only seeing 16-18 PSI in sport...
  7. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    Ordered a pair of these today. Probably going to run those and the hitch light together. If we ever have to use the hitch; we'll still have another set of brake lights.
  8. Official: Ford Performance Tune Released for Bronco Raptor for 455 HP / 536 LB-FT Torque [UPDATED]

    What are you seeing your boost top at out from a slow roll or even 45 roll with pedal to the floor?
  9. Official: Ford Performance Tune Released for Bronco Raptor for 455 HP / 536 LB-FT Torque [UPDATED]

    Anyone notice during the tune upload, to the Braptor, that a few blocks either skipped or just installed so fast it looked like it skipped a Block?
  10. What Did You Do To Your Bronco Raptor Today? 🔧 🧰 🪛

    Yes sir. I put them on the pair that are on the overhead switch panel. I think it was worth the $12. ETA: The light is a little more yellow than it appears in the photo above. iPhone kind of gave it a little green tinge there. Here’s a shot with both sets on.
  11. OFFICIAL - BRONCO RAPTOR PROCAL 3.0L ProCal Tune COMING JULY 2024 [FORD PERFORMANCE]

    When it's plugged in to the vehicle you should be able to see the tune loaded to the PCM. Check under Module Info maybe?
  12. OFFICIAL - BRONCO RAPTOR PROCAL 3.0L ProCal Tune COMING JULY 2024 [FORD PERFORMANCE]

    How long does the performance tune flash take? I know it needs to be connected to the Raptor, original tune stored, plugged back in to the computer to backup factory tune...download performance tune to procal then back to the Raptor.... How long does that final step take? Just want to have a...
  13. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    Just looked in to this for Texas. ".....The Center High Mounted Stop Lamp must not be mounted less than 15 inches, nor more than 72 inches." I bet our hitch is higher than 15"!!!
  14. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    Here's a photo of the actual wiring. Two 7 pins get plugged in inline and the grey/orange connector goes to the actual light.
  15. Third Brake Light Replacement - Diode Dynamics HitchMount C1R+Brake

    You disconnect the back of the 7 pin and the light has a male and female 7 pin to wire in line. The "female" receptacle, already on the truck, actually has a male 7 pin plugged in to the back of it. You unbolt the bracket and you can disconnect that male plug from the back of the receptacle...
  16. Procal issue connecting to computer

    Someone in another thread said they had to use a different USB cable than the one in the box
  17. Procal issue connecting to computer

    Are you running WIndows 10 or 11? If you're running 11. Try right right clicking on the Application. Select Properties. Compatibility Tab. Check theRun this program in compatibility mode for: Window 10. Click Apply. Click Ok. Then try opening App and plugging in again.


Top