Search results

This whole sync issue caused me to bite the bullet and purchase the hardware needed to run a FDRS session and update all modules on my own. I have a post you can search for if you are interested in that journey. In my case I had other modules that needed updated before the 6GB SYNC update would...

Yep a dealer did the same thing to mine. I asked that they color match plugs before pickup. If you look close, you can see they did not even follow the pilot holes when they did the original drilling.

In my case it was the connector to the rear camera that got wet. It does not appear to be waterproof. WolfBox sent out a replacement rear camera and cable at no charge. Since I installed it, placing heat shrink tubing over the connector, I have had no issues.

This will be great when I upgrade my tires. Does anyone know where to find the smaller (Raptor) rubber bumper spacers? It is my understanding from another post that they need to be trimmed to accommodate the width of larger tires.

I found that additional updates would appear in FDRS after I successfully completed the ones initially listed.

Yes I remember seeing your video on YouTube a few months back. I love your approachability and disposition. Super helpful when I was determining whether or not to try FDRS. Bricking a phone is one thing, a vehicle . . . A completely different level of pain.

Thanks. I really appreciate this community. Would not have been able to do half of the programming on my rig without the knowledge here!

This is working great for me. Make sure you put heat shrink tubing over the rear camera connector. It is not waterproof. And big thanks to WolfBox customer support who had a replacement sent out asap. With my setup you can also have a ‘rock crawling’ mode by flipping it down with the...

I just took the journey down FDRS updating my Badlands. I followed this guide which has been mentioned before: https://www.f150gen14.com/forum/threads/ecu-module-programming-guide-using-fdrs.8249/ It’s an accurate and great write up. I purchased the Mongoose-Plus J2534 and Clore 20-Amp...

Just successfully installed a Midland GMRS antenna through the ‘nipple’ into the cabin. I did not see it mentioned anywhere in the thread that the grommet can easily be pulled out towards the engine bay. From there you can use an x-acto blade to make a star pattern. Since the antenna was larger...