Question for those that installed the NVM, did you paint or coat the bare metal with anything? Wondering if I should at least put something, but then again it’s made to be scratched up so…
I’m on the west coast so no salty roads to worry about
I used the bumper shims on mine, but I don’t really like how it makes the bumper stick out a little bit. I assumed it was needed to clear the front of the skid plate, but if it’s not needed I will definitely be taking them off.
Hi guys I am installing this on Monday and recently added the ford pro cal tune. Will the rack still be plug and play or is there some programming that needs to be done with the pro cal to get it to work?
Do you have the gatekeeper knucklepods? If so, can you record a video if you get this working? Thinking about doing that and would love to see it in action!
I noticed this too. I think it’s because the adjusters on the headlights are very sensitive and loose. Not sure if there’s any way to tighten them up.
It’s not much, but I 3D printed a MOLLE panel mount for my goal zero charger so it’s not banging around in the back.
I also 3D printed this mount for the milkwaukee paper towel roll holder to install it over the roll bar
I was going to order a wiring kit on Amazon that has 16 awg wire. Is that sufficient? Also, will buying better speaker wire actually make a difference? There’s a ton of kits around the $20-50 dollar range, although that seems like it would work I really want to do this right one more time. I...
I’m coming from a kicker key 200.4 so I think all of the necessary forscan changes have been made, at least the ones mentioned in Ragnarkons threads.
I can’t remember if I wired the speakers using metra but that does look familiar. The directions aren’t very clear, so you just just cut the two...
Thanks for this. I have taken a look at the manual and I believe I would need to use the input circled in red. Can you confirm that?
So at a minimum I need to run new wires to the dash speakers and disconnect them from where they join up with the kick panels.
Is there a benefit to also running...
Thanks for your response, but I am confused. Is that not the only way to separate the kick and dash panel speakers? The plug n play wire harness has the speaker outputs pre-wired, I assumed I would have to cut/splice something to go from 4 channel to 6 channel, just unsure of the proper way to...
I recently ordered a musway six100 from plugnplay, planning on using all six channels to control the dash, kick panel, and rear speaker pods.
Has anyone successfully separated the kick panel and dash speakers channels? Please provide instructions if you’ve found them, I tried searching but...
Sorry if this is a stupid question. I installed an adjustable rear track bar and just eyeballed it when I installed. I haven’t noticed any problems with it, but I want to properly adjust it. Are there any instructions on how to do that?
I did see a YouTube video from wild horses a while back...