Search results

Sorry this happened to you. Keep us informed as to how your lawsuit goes. Lawsuits take years, so I expect that it will be sometime before this is resolved.

Thanks!

Wow! that surprises me that it is so little. Many of the kayaks that we are looking at are around 60 pounds or so, which means that we couldn't carry two on that roof mount. I guess we'll need to keep looking for a solution.

Love the handy flag! Seem like good folks too when I communicated with them. I like this idea, but if we get kayaks, I think we'd be using the trail sites as a tie point, which may rule out the flag mounting idea.

Good point on this one. Didn't think about that.

Hate to resurrect an old thread, but we're considering kayaks and this is the best solution I've seen so far. One question I can't find the answer to. How much weight can the factory roof rails support? The ford site doesn't give *any* technical details on load ratings.

Love your graphics! I guess I can't see any reason to mount front over rear or vice versa. I guess pick one you like and just go with it!

I like that idea! Great color on your bronco (same as mine!).

I've used radios for a long time and I don't have a lot to add except for the thought that you could consider your use case before you decide what radio to buy. Sticking strictly with GMRS as that seems to be the current trend for off-roading, there are really two use cases that I see. One of...

So we just returned from a week down in Sand Hollow, UT. It is a state park and in order to run around their open riding areas you need a safety flag mounted at least 10' above the ground when in motion. I noticed that some folks tend to mount their flags on the back of their vehicle, some on...

Man I'm sure sorry that this happened to you.

Those procedures posted in @Az_Squatch_Bronco's post were a workaround for a problem caused by Ford. The problem was fixed via an update earlier this year, so you (supposedly) don't have to wait, pull fuses, etc.

Watching this thread and wondering what I can do if I end up with a failure like this. Perhaps filming us putting it into neutral tow mode and showing the "neutral tow enabled" message? Would that be enough of a record to show that the bronco was in neutral tow if a failure like this occurs?

I flat tow my bronco and now am worried about something like this happening. Any update for us? Someone above mentioned a "digital trail" and I was wondering what that was.

stupid question. How do I tell what version I have?

Not sure which sub-forum to post this in. None mention airbags. Just finished installing my flat tow braking system, GMRS radio, and other such goodies and I now have an airbag warning light on. Anyone know where the sensors are located so I can give them a quick once over before I take the...

If that is the case, then that is where mine will end up as well.

Do you worry about mounting things in that cooling area? The upfitter's guide says be careful about restricting airflow in that area. I'm struggling on where to mount my 6 way and break away box on my modular bumper.

Thanks! I've been looking for that everywhere.

I'm just now installing the LOD front bumper tie in brackets and am getting ready to remount my modular bumper. Anyone know the torque specs for the bolts that mount the modular bumper (the 6 bolts around the recovery points)?