Search results

Also - look at this post: https://www.bronco6g.com/forum/threads/how-to-magsafe-wireless-charger-install-in-factory-location-diy.32069/

The flush mount plate was 3D printed using a variation of: https://www.thingiverse.com/thing:4936062 The wiring harness is amazing and found at: https://www.4dtech.com/12v-pnp-power-accessory-harness/ It plugs into the rear 12V and then has connections for the rear 12V and the power unit. I...

The blue ring and disc covering the mag charger are stickers. The sticker pack came with black. the place where the charge pad is placed is screwed into the console at an odd angle. You may could unscrew them - but it’s not hard to remove the console. I understand the stock charger is not...

Just did this today. Works well - fast and all wires under the console.

I am in the middle of this project on a manual transmission Bronco (Black Diamond). The steps are very similar. Pictures are how to remove the gear shift knob and the rear access to the console - so that wiring can be done without removing the console. I will post more pictures once the...

is the gear shift know just screwed to the post - the directions seem to imply that there is a procedure for that too.

Do you have a similar PDF for the manual transmission?