Search results

It was BearMetalOffroadUS . They have closed their store and I Couldn't find a website. https://www.etsy.com/shop/BearMetal...CtyDR96jcI&eaid=14725675606&x_eaid=014c0da176 you can see pix in this thread... https://www.bronco6g.com/forum/threads/hard-top-front-panel-support.99677/#post-2317861...

Nah, not imagining. In my past search I found 2, one from a fab shop/guy that sold them on Etsy for around 275. The other was more elaborate and could include a light and was from an off-road place but it was 5-600 bux. I almost bought the first one but when I finally decided to he no longer...

How about a pool noodle sectioned out to fit along the short edge of each panel and stand them up on the left (or right side of the back. Then just bungee them taught? Gonna try that one eventually myself

Sorry never replied to this, if you still need it I'll pop open the fuse box and get a photo.

Cheap enough that if they break I'll just buy another set. I think like 60 bux from ali-express. Stuck them to my Bronco seats and put the Mabbett covers over. Still working well! (Well not today ...it's 92 out)

Same here..I still love 'em. Had the for the better part of three years and aside from the fast blink inside on the dash (the outside blinks normal)...which I believe is just the resistor pack (first one side then the other 6m later) gone south. I would buy again!!

Any guess on timing for the 2Dr back window and cover?

Well that was quick...Sale over?

What do the rear holes tie into in the first pix above? Thats where maybe the confusion comes from? Until this picture I thought you only attached in 4 places but it seems you attach at 8 points?

Bronco 6g Roof Support - Etsy https://www.etsy.com/listing/1710904968/bronco-6g-roof-support

If you're worried...there is a guy on etsy that fabricates a nice "bronco roof support bar" (search that) that installs and allows you to clip the rear center mounts to a rigid support. Its about 250.00 but looms to have some decent design and craftsmanship into it.

Something like these on Amazon for 10 bux ea? Aaleds 12v led Light Strip, 3Color Dimmable 10.5W 1500LM12 Volt led Strip Lights 12V fixtures for rv Interior, 12v led Ceiling Light bar for Enclosed Cargo Trailer, RV, Van, Truck, Lorry Camper/2PCS https://a.co/d/aPEtqF8

Nope, you are simply tapping off the hot side....kinda like making a splitter. You still maintain the integrity of the circuit, you're just drawing off to another fuse.

Do they seem to throw a lot of light or are they more for visibility?

As stated above...Running w/o rear seats and top off i would instantly buy a solution that covers the back area from the primary seat backs to the mounted spare.

Gorgeous hardware! Any pointers/lists/links for hardware you used? TIA!

Never mind :-) searched Bronco Support Bar and boom...

Use a jam nut screwed onto the thread b4 you instal then tighten the nut against the dash w/ a wrench.

Ok, I'll come out up front and say this is NOT criticism, it is in the interest of learning from your experience ....if I ever get off my azzzzz and try to replicate. 1) Fan - effing - tastic! very nice design and execution! Q1) why the snaps rather than some sort of HD Velcro as i have seen...