Search results

UPDATE: Added some night photos of the inside of the cabin. Last pic came out a bit blurry, but you get the gist. As the title says, I finally got around to installing the @AIGMUX interior LED lights for Ashoka. A lot of things have been going on, but today, I said ok...I am going to get this...

So this will be a quick SIGHT review of the new @AIGMUX Grab Handles V2 with LED light. I say quick review because these handles will not work with my setup. I have all may know, an Armadillo Slant Back top. The place where these handles bolt in, *On the top rail* is covered completely by my...

So this will be a quick SIGHT review of the new AIGMUX Grab Handles V2 with LED light. I say quick review because these handles will not work with my setup. I have all may know, an Armadillo Slant Back top. The place where these handles bolt in, *On the top rail* is covered completely by my top...

As the message says, I am looking at tuning options. I was thinking of the Ford Procal like I have on my Badlands, but now that the ECU is open, I was thinking about a custom tune. 1. I know about Goosetunes. Good service, Good tunes $$$$ 2. I know about ZFG tunes. Good tunes, More time on...

As the title says, I need to get some new grab handles. My pull-down from Jessable does not work on a Braptor. The Spartan 7's I had replaced do not fit because they interfere with the unlocks for my Armadillo top. I do not want to use the bungie style, and I want more light in the cabin. So I...

Atfter being inception from this very forum, I went out and purchased a 2024 Bronco Raptor. I am amazed by just how well this vehicle drives. I have a very heavily modded Badlands. It has handled everything S. FL has to offer. I did not think the BRaptor would be this much of an improvement...

Evening, fellow Bronco enthusiast. This post is to give my honest view on the new Caroboter Digital Gauge Cluster for the 6th Gen Bronco. This cluster is new to the Bronco world and was just released on 8/28/25. The vendor is not new to the off-road world and has made several different...

So after seeing some others do this, I decided to go and replace my Leather Lux wheel with a Carbon Fiber Flat bottom Leather wrap one. I decided to do a small write-up because I have seen questions asked, but have no answeres on certain aspects of doing this. Soooo...... 1. I have the Lux...

So a little while ago, @AIGMUX reached out and said they would design a molle pouch for the rear of the driver seat and passenger seat. I signed up for this, and it has arrived. The pouch is well-made, sturdy, and covers the rear of where the cargo net is. It has molle straps on the front to...

As the title says, has anyone paired the two together? I am wondering if the taigate will fit with the slide-out, as the slide taigate has a higher floor. Thanks in advance.

I have a question for the forums. I have Warn Bumpers front and back. I no sensors on the front bumper, but all four in the rear. In the settings, the front sensors are turned off. The rear sensors are on. The problem I have is that sometimes, most times, I get a PARK AIDE sensor error. But...

So this is the issue. I have an ARB single compressor mounted on an American Adventure Labs Tailgate mount. The compressor is connected using AAL revised harness, power is ran up front to the battery. When the compressor is connected, it works fine. When I connect the pressure control system to...

Evening my fellow Bronco enthusiast. I have looked but not found a lot of information on the American Adventure Lab tailgate mount for a single ARB air compressor. I had thought that I really did not need a compressor as I do not air up or down as much, but as of late, I been thinking hmm...it...

As the title says, BlancoBronco Adventures takes (steals) Armadillo Design bronco to test and speak on the new Armadillo top. See the video below.

As the title says, I just looked at a video from @TCcustoms.com that speaks on the hidden features of Ford, for 23/24. The one that stuck out, was that the Bronco will receive a MOD top later on in 2024 that will be coloured match to the Bronco.

As it says, my ditch lights which are on switch 3,4 my fog lights on switch 6, and now my light bar switch 2, have stopped working. The light lights up inside for the number, but the ditch lights 3,4 just flicker. The Lightbar stopped working this morning, but I see that the fuse blew. The fuses...

So, another mod completed. This one was for my rear tire carrier. I have the DV8 HD tire carrier with the accessory guard. Now this is a great carrier, I love the way it is set up. What the issue then you say? Well, it uses the OEM carrier. In my case, my OEM carrier was damaged. Not sure when...

As the title says, I finally received my Injen hot and cold charge pipes. When I purchased my CAI from Injen, I was told they would be doing an intercooler and charge pipes for the Bronco. The mock they had at Seema were chrome charge pipes that looked nice. The released pipes are either wrinkle...

Not sure if anyone has seen this or if it was posted here already, this is a video of the My Top automated top for the Ford Bronco. I believe Jeeps have one, and now they have made it for the Bronco. Should be released Q1 of this year. https://mytop.us/products/mytop-convertible-bronco-top

Things are heating up! Rally Tops posted a new video on YouTube of their Hard Top solution. Have to admit it looks pretty good. Shows exterior and interior shots, with the sections off as well. I think they want people to know they are in the game as well.