Recent content by Smokey142

Yes they finally came in at the end of March, over all I like them. I still think they’re a little pricey for what they are. I’ve used them on my hard top and soft top and my only complaint is that they block you from lifting the soft top when trying to get into the trunk area, but they work...

I emailed but no answer

Originally when I order the XG cargo gama bags it said they’d be shipping in September/October. They then changed the website to say November/December and it hasn’t changed since… has anyone received their bags yet or are they just delayed again? Does anyone have any updates? Thanks again guys

I have the tailgater, I’d definitely buy it again. I like the magnetic strip it comes with and the slide out table extension is larger than the others on the market.

I added a folding antenna mount from Amazon, I ran the antenna wire up the C pillar of the roll bar and then down the rain gutter and out between the panel. I mounted it to the side of the bar so it can fit in an 8ft garage. Folding antenna mount

I have the same rack as you, I’m trying to find a good way to mount it on the rack. Current I have it mounted with a ram ball with no extension and the antenna wire is ran between the roof panels and down the roll bar into the rear panel. Unfortunately the ram ball mount broke so I’m trying to...

The internal antenna only has a range of about 3 feet max, so if you’re mounting your phone to the dash the internal antenna being by the switches would work, but if your phone was in your pocket or the console you would be close to the edge of the range

* disclaimer - I’m not an expert so take everything I say with a grain of salt. For orientation I’ll describe the wiring from the weboost to the switch I’ll start with the hot side (red wire) I took the cigarette socket 12v cable that came with the weboost and cut the end off, if I remember...

Also would like to know, maybe some has done this in forescan

Bump

Adjust the rubber bump stops that are under the hood at the front corners. They just screw up and down and will raise where the hood sits and also stop the hood flutter when driving down the road.

Badlands non Sasquatch, Method 705 17” +35 for the tasteful poke with skinny fender flares. Tires are the stock bfg K02

Unfortunately I did the same thing y’all did. Here’s the part you’ll need https://parts.ford.com/shop/en/us/body/instrument-panels/stop-14756047-1?pdp=y

Went to install my rack and the rear right side clamp will not tighten enough to clamp down all the way. The geometry of the right side is all messed up. edit: I disassembled the entire clamping mechanism and reinstalled the hinge and bolt mechanism and it seems to work now.

Side mounts are badass tents but the top rail looks custom with aluminum extrusion cross bar