Recent content by sklnbnzaz

Here you go! 8 Wolfbox Nomad Rover 5" lights as a light bar. Installed on the Motley Industries Overhead Light Rail. I ran separate wires to each pair. Came off each side, down the A-Pillar and through the driver's grommet. Used a single one of the included switches and it triggers all 4...

I will be installing 8 of the 5" as an overhead light bar tonight (and tomorrow). My plan is to keep the relays in place so it is 4 separate circuits for power draw considerations, however control all four sets with a single trigger switch point. I will report back on the installation. I will...

Wolfbox is going all in on the gear for sure! These look great and their new dual onboard compressor is great too.

They are out

Looks like they’re getting close

Steve and Bill are on the way. Probably an hour out. They’ll be coming in from Pobricito

Are you still stuck?

Good Feedback. I will let their Marketing guy know when I see him next. I get out on the trails with him from time to time

The DV8 Team is great to work with. They are here in Arizona along with ADD, Flatline Van, Rago and C4 Fabrication. The ADD Manufacturing facility is impressive.

You can do it without pulling the bumper completely. You just have to reach up under there. It is easier if you loosen the bolts so it drops down a little bit though. That is what I did. And YES, I messed up the factory sensors bezels as well. Partly because I was tired an impatient after...

I have since changed the fairlead to the Mojab fairlead and hook and it is great!

Sensors were the toughest part to get dialed in. I changed the rear bezels to the flat ones and used the existing on the front. They are pointed down a bit and do line up. I took a photo on my mod bumper beforehand though.

The one that came with my Bulldog Winch

Some photos… long trail weekend so dirty…

There were zip tie tabs along the bull bar and also underneath where the in bumper light bar is and the pocket light bar are. Lots of them. I would check with their support. I ran everything along the bumper and up in to the driver side battery compartment area