Recent content by Rumbloki

1000% in on this!

To hold a wheel on a 5000# vehicle? Not for me. Also, I would be concerned about bearing damage using a hammer. There are several different tools for this, maybe rentable.

The red one.

Black Diamond 7sp with base or OBX tires. Add a tune and downpipes.

ordered

My bumper was free, but it was missing the plastic covers around the recovery points. The four brackets were needed for the sensors. The sensors I ordered from amazon didn't work. The ones that did work are NU5Z-15K859-DG. Maybe your sensors aren't flush because they don't fit (not angled)...

I'll take one.

You are correct. They are different. I replaced my capable bumper with mod. I needed four bezels and two angled-connector sensors.

Mid-engine.

No turn signal. Ford calls it a spot light. You will need the correct switch panel to operate them. Intended for off road, they only work up to 5mph. There are aftermarket units that have turn indicators.

I would never use a Bronco hitch as a recovery point. It mounts to a cross beam that is full of holes. This is the main reason the tow capacity is so low. Hitches on other vehicles mount to the stronger side rails.

Eco sucks so bad, I removed it.

When does that happen? My only complaint is the 5mph limit on the mirror spot lights.

This is how you make a wheel/tire post, people. I can't believe how many people post their new setup without including the specs.