Recent content by Rednek

Have you tried turning off lane keeping,it can be sensitive at times,also ask dealer if they reset ipma after alignment for lane keeping correction.

Do what pleases you, Trudeau salute for haters

Just the drive looked like a workout

I changed the fixed jack on my teardrop trailer for a fold away jack with side mount crank,works way better and allows me to open gate a bit more.

As a dealership tech and shop foreman for 25+ years I've seen a lot of the finger pointing of blame,vehicle comes in for repair and comes back with a unrelated issue (you rotated my tires now my phone won't sync you must have done something to it🤪) Sometimes it's just bad timing things break...

twit tok crap

Parks like a dick....... Check

Item Description 1 Accessory drive belt safety shield 2 Accessory drive belt tensioner 3 Coolant pump pulley 4 Accessory drive belt 5 Generator 6 Generator safety shield 7 Crankshaft pulley 8 A/C compressor belt 9 A/C compressor 10 Accessory drive belt idler pulley ©...

is it dual zone or regular?

I did this repair on mine just before warranty was up,is a very common repair i've done on the 4 and 6cylinder engines (silicon sealant doesn't seem to like extremes in temperature that we get in frozenland)

I had a simular issue on my 21 2.3l a/t,was pulling my new teardrop trailer home and at highway speeds a deer jumped out from ditch applied brakes and no assist at all! Turned out it was a bad vaccuum line to engine.the 2.7 is a different beast as it has a electronic booster.

Not sure why they haven't responded to you but when one of my mudflaps broke in half they replaced it,It took a little while to get to me because they were out of stock at time(2weeks)

New badging

Funny enough every ad below the op post shows a junkyard lol

This looks like a good power solution for my cameras,but might have to do modifications to work with my AR rail but hey i'm always up for a challenge.(makes for good content)