I had this issue previously and performed the following steps, posted by another member, which resolved it. I have not had it since.
Lower window, hold window switch five seconds. Raise window, hold window switch five seconds. Repeat two times. Roll window back up. Exit vehicle normally.
Iām just curious if there were any other solutions to this. I took mine in for some repairs to the wireless charging and a couple of other technology related issues, along with a noise from the top. Now that I have it back, it stinks horribly. I took it back to the dealer and they cleaned it...
That sucks, but at least warranty should cover it. I am in Oklahoma and while it is parked in the garage at home, parking at work is uncovered and in direct sun, but I have not had this either.
Nice job with these. I bought these same ones and they are very tough. I have been mulling over how to attach them. I donāt have crash bars, so I think I am going to bolt on some angle iron to the crash bar location so the tires still clear, and attach the flaps very similar to this.
I am looking for the same thing. I just found this, but it is pretty expensive.
https://www.texascompletebronco.com/products/roof-rack-for-soft-top-broncos
This is a full tie rod that will be much stronger. The sleeve attempts to address the weakest point, but the whole factory tie rod is junk in my opinion.
Here is what I ultimately want and probably what we need, but I am not ready to pay for it. Thank you Ford for using toothpicks for tie rods on an off road vehicle. š”
https://www.rpgoffroad.com/product/bronco-full-tie-rod-kit/
After reading another thread it looks like that the options are there for many, but do not work until after the aforementioned update. Guess I will be making a trip to the dealer.
So, I have the same issue and it is really annoying. I disabled every sensor in the menu and it still beeps with my bike rack on there. Not sure what the point of having the the ability to disable them if it does nothing. There is a physical button on the dash to disble it, but that is only...
I actually just deleted them when cleaning up my photos, but the post for replacing the Wireless charging system made by another member has some diagrams.
https://www.bronco6g.com/forum/threads/how-to-magsafe-wireless-charger-install-in-factory-location-diy.32069/