Recent content by mohavecustom

Not a lot of room back there to play with, especially with a soft top moving around. Lots of trial and error, trust me! 😂

https://mohavecustomdesign.com/products/starlink-mini-roll-bar-mount-for-2-door-ford-bronco

Thanks for the shout out! We have mounts for Bronco Raptor, 4-doors, 2-doors, soft-tops, and a dash mount now too. Appreciate all the support we have gotten from Bronco6g

Hello, Could anyone help with a question about 2-door soft tops? We are going to be releasing a new Starlink Mini mount for the 2-door Bronco. It has been tested for the hard top and is almost ready for prime time. Uses 2 65-pound magnets to keep it secure between the roll bar and roof. The...

Hi all, Continuing to put out new solutions for mounting the Starlink Mini in your Bronco. Introducing a new simple dash mount for the Starlink Mini. It uses the factory 1/4"-20 mount on the dash of all Broncos. Built with ASA UV-resistant plastic. Mounted with a single bolt and washer...

Hi All, New solution for mounting your Starlink Mini to any AMPS universal mount. This mount locks directly in to the bottom of the Starlink Mini. Supports both 4-hole and 3-hole AMPS industry standard mounting. Commonly used on RAM, Bulletpoint, Tackform, ProClip, etc. ball type attachments...

The mount is specifically designed for the 2025+ newer style OEM pole mount. It is taller than the old version, which it sounds like you may have. Edited the website to make it more clear. Here is a link to the newer style adapter on the Starlink Shop for reference...

Hopefully soon!

Keep it from getting too tall, and lower of center of gravity with the height and shape of the mount. The mount is actually flat on top, the pole mount from Starlink has a built in tilt. I don't find the angle vs flat tolerances matter too much anyhow.

No, only the Mini

I looked at your Youtube Short for your mount. Looks intriguing!

Oh ya, I use it out in the desert all the time. This thing is pretty overbuilt with thick ASA plastic. The only thing I've had to do is load up the threads with loctite, but the mount itself is solid.

Yes Yes there is. Once the pole mount is attached to the mount, you can snap the Starlink on and off.

Right. Yes, using the factory bolts on the Raptor. Ships with bolts and washers for the regular 4-door. I would recommend thread locker on the bolts, and on your Starlink pole mount.

I don't believe the 2-door has the pre-threaded holes on the rollbar. I checked on a 2023 Wildtrak and it didn't have them.