Sponsored

Recent content by Minimalistik

  1. ARB CKMA12 single compressor install with factory aux switches

    I got the package with pump up kit but you also need to get a decent inflator with gauge or your'e flying blind with the pressure
  2. ARB CKMA12 single compressor install with factory aux switches

    Nice! I had same issue and finding info about single was hard. The wire harness they sent was a bit much so finding out what i needed was perfect.
  3. DV8 mto rear bumper installed. Blind spot warning on left side now going off

    I have the front MTO and the roof rack. Front bumper was a pain to get on but made it work. Was about to order the rear MTO bumper and noticed reviews on their own site say it blocks the sensor. What’s frustrating is DV8 clearly states it does not block the sensors even though they have known...
  4. DV8 Offroad | 10% off for Bronco6G Forum Members

    Rear MTO Bumper A-Pillar Pod light Mount Crash Bar Caps Straight from your site. It worked when I did roof rack and front bumper a few weeks ago.
  5. DV8 Offroad | 10% off for Bronco6G Forum Members

    forummember does not work anymore however save10 does work
  6. DV8 Offroad | 10% off for Bronco6G Forum Members

    This code appears to not work anymore? Can DV8 confirm or offer a new code?
  7. DV8 Bumper and Winch install

    What I did is take a small stick and insert it from top of engine compartment behind drivers headlight going down. There is a small path there. Then tape the winch cables and any other wires for lights to the stick and pull it back up. Blammo! Cables all in and just need to zip tie to secure...
  8. DV8 MTO Front Bumper Installation, ACC Relocation, Parking Sensor Transfer, and Winch Mounting

    Got them all now. 1) using the nut plates I got all 3 bolts on one side and one bolt on other side. 2) loosened bolts on the successful plate side to give some wiggle. Removed single bolt from failed plate side and held bumper up with hi lift on now free side 3) I was able to remove the nut...
  9. DV8 Offroad Front Bumpers

    Why are you not using the nut plate on the install? My hardware did not come with mounting nuts and that seems to be common with some other people.
  10. DV8 Bumper and Winch install

    Same issue here. They did not provide nuts for the mounting. Trying to use the nut plate and got most of them in but having a hard time with one side. Not sure why they would not use the mounting plate and I am going to try to make it work. I also have huge hands and these thirds bolts are...
  11. DV8 MTO Front Bumper Installation, ACC Relocation, Parking Sensor Transfer, and Winch Mounting

    Been working on my MTO bumper for 2 days now. Good lord those third bolts on each side of the bumper are crazy to reach. I'm out of swear words and the wife is ready to kill me. Didn't help that the capable bumper i removed was a pain to get off the sensors.
Top