Recent content by mhorvath1218

Yes it is and its still available

Pedal commander PC18 throttle response controller. Had this in my ‘22 Bronco. Traded it in and no longer needed, but works perfectly. Pickup in Bergen County, NJ preferred, but I can ship it.

Thanks man. Turns out I had a major brain fart moment and forgot to reconnect the electric connection for one of the brakes. Totally my bad! Lesson learned!

Bringing this thread back up because I’m losing my mind trying to get out of maintenance mode. The cheat code doesnt work. Tried like 20 times. It worked to enter maintenance mode. I tried using forscan, but when I run the exit procedure it cancels every time and says service procedure...

Correct, no trimming needed

I just had to trim the rubber bumpers behind the spare. Used a utility knife to cut them down. Took a few tries putting the spare on and off, but got it right eventually. I still have the same setup and have had no issues the spacers. The 35’s just fit under the brake light so no adjustment was...

thank you! Yes I do have Forscan and the cable to connect it. I’m willing to work through a fix if I have everything I need already. I really appreciate your help. Based on the time stamps I see in the 2nd photo, I think I know what happened. That was right around the time I got in my bronco...

A few days ago I noticed my Bronco stopped showing the song and artist names on siriusxm channels on the main audio screen and weird display glitches on the right side small audio display. Check the photos attached. I tried restarting sync several times with no improvement and then checked the...

Agreed! Mahwah was a lot of fun as always. Got a few new gouges on my wheels to remember the occasion haha. Also the shared photos folder was a great idea, thanks Nick. And I’m sorry I didn’t get the names of the guys shooting with their cameras, but the photos came out great! Thanks guys!

I bought Mishimoto’s “Borne off road” 30mm spacers for my non-sas badlands. With stock wheels, it equates to roughly the same offset as Sas wheels. I also installed 315/70r17 KO2’s and have non-sas flares. I think the poke looks perfect and have 0 rub. Nice quality spacers too.

You plan on making some more of those brackets? Love the look and simplicity!

Thanks, that was the goal. This stuff took about 15-20 drill holes with a carbide bit around the perimeter of each, then a heavy duty dremel cutting wheel to fully cut it out, then lots of sanding/grinding to smooth and paint to rust proof. Ended up being more work than I would have liked, but...

I did the exact same install with DD SSC1’s running a red backlight when the taillights are on and white in reverse and with an aux, however mine were installed in an aftermarket Barricade steel bumper that did not have cutouts. Cutting through the MUCH thicker steel on that bumper vs the stock...

Shopping for some 35’s for my non-sas badlands. I’d like to stick to a load range C tire and saw the Wildpeaks, however Falken’s spec sheet lists the max psi as 35. Considering recommended pressure on the door sticker is 39, does that mean this tire would not be a good choice? I’m aware that I...

Got in a slight accident a few weeks ago and banged up my rear factory bumper, which gave me an excuse to get an aftermarket one. Barricade Extreme HD. I cut out and installed DD SSC1’s wired with their backup lighting harness. Red backlight runs with the tails and white flips on in reverse or...