Recent content by MattyC

Thanks. The noise is subjective really. Even though its noticeably louder, people who ride in the car say it doesn't really bother them too much on longer trips. It's possible I'm just anal about it because I know how it used to be vs how it is now. I can try to get decibel readings from an...

Hey There, I don't have the KC's but I do have the Quakes. They are circular as well. I also have a soft-top. For me, it isn' too bad up to 40 MPH, when you start increasing speed from there, it gets louder and louder. It's still not TOO bad, up to about 60, after that it can get a little...

I added the Quake Monster Pod Light Bar. Making sure everyone can see me coming.

Im not 100% sure ... I can probably check it on the weekend and see what they are set at.

Happy Thanksgiving to you too, and the rest of us 1/24ers.

I get 17.4 MPG consistently myself.

Sure - basically I connected all the power wires to the LED letters together then to an upfitter switch, next I connected each ground wire to a MOSFET. Those MOSFETS are then controlled by an Ardruino Nano. You can program the Arduino to do whatever you want the lights to do - the code isn't...

Saw somebody on these forums do this awhile back... figured I'd give it a try myself... came out good!

I went with Hoel Wiring. Cost me $90 for a wiring harness with kicker key 200.4 in Bi-Amped mode. He was very responsive in helping me out and he also replaced a faulty part quickly at no cost to me.

I have a t harness and another harness that wires everything up in bi amp mode. The harness comes with wires to run to the dash but uses factory wiring for the kick panel speakers. I also ran the power off the battery instead of loop back. Since it's bi-amped it is only wires to AMP 1...

Im not 100% certain, I got a harness from Hoel Wiring made specifically for BiAmp mode. Not sure what's different.

I have the exact same - but bi-amped

Dead center.

I didn't have to add the bass blockers when my key auto-eq'd. Sounds perfect through all volume range. When you Auto-EQ'd did you have Bass Treble all flat when you ran it?

This happened to me when I had the Stubby antenna installed. Put stock back on and doesn't happen anymore.