Recent content by Lobber

Looks like an epic trip, thanks for sharing! I have been on all of those trail and they are some of the best Colorado has to offer! Full disclosure I did Holy Cross before I had my Bronco and just last week I chickened out on Wheeler lake after the cement mixer because I was not with any other...

I bought this kit and a 13K ZESUPER winch off amazon because I figured it was similar quality to the RC winch and cheaper so I unboxed everything and was making sure it would go together properly before I started taking the Bronco apart. One issue I noticed was that the plug in extension cable...

@T Copp Absolutely!

Broncos & Coffee this Saturday June 25th, 9am at Ten & Two Coffee in Bonner Springs. For those that can make it I will be passing out KBC stickers. Ten and Two Coffee 611 W 2nd St, Bonner Springs, KS 66012 https://goo.gl/maps/ojAz8jnZhieAgPkG8

You need to run a power cable and the power cable comes in the kit.

Yeah I’m not far from you, Tonganoxie.

Well you were right ended up being way too much rattle even firing towards the seats so I moved it inside the enclosure on the side wall and that took care of the issue.

Yeah the Kicker Key 200.4 and all Kicker CS series on the factory replacements.

Has more bass than I will ever use. Yeah upgraded all speakers to Kicker. Not a B&O.

I put some foam padding strips in between the sub and enclosure and the few minutes I have listened to is so far didn't notice a rattle but could end up being an issue I will update if I end up having to make some changes.

Yeah thought about that too but I like it hidden.

Finally got this kit installed and super impressed with the results! The system sounds amazing and the plug any play kit made it a fairly simple install, probably took me around 4 hours but didn’t get in a hurry. Also if anyone is doing this setup and has the cargo enclosure the HS8 Sub fit...

I just check their website and is still says "coming soon" for the Bronco how did you get an order in?

I'm have the HS8 sub I'm going to install and was wondering if you connected the remote wire to a aux power source or did you just use the DC offset function? If you did connect it where did you tie it in and if not is the DC offset working good? Thanks!