Recent content by kunzy

I also have them and am really impressed by the ride and handling on the road. Unfortunately, I have not had much opportunity to test them off road, just gravel and some mud. They have been on my Bronco for over a year and still look like new.

I have a Addictive Dessert Designs Bomber front bumper. It uses three lights. The Rigid 360 series lights come in pairs. I had to buy a pair of lights and only used one light. The other is still in the original packaging with all accessories. They currently cost $630 for the pair. I would...

Sorry. I recycled them. They are gone.

I have a 23 Badlands with a Fabtech coil over 3 inch lift kit. The bottom of the shock is about an 1/8th of an inch lower than the shock brackets. Would these fit my truck? I have bought other stuff from you and am really impressed by the design and quality, so yours would be my first choice...

You're welcome.

Hi. It was easy. There was enough room to get the bolts through with no problem. I have a skid plate and just loosened the bolts on the skid plate.

Yes 20 degree and yes more room for step in back. You're welcome.

Hi. Sorry for the delay. I have been very busy at work. I hope these help. There is enough room to make a decent step without a running board look. My wife likes and uses them.

The sliders are angled up. I am pretty sure that it is 20 degrees. Install was easy. If you do it by yourself, like I did, block it up. I used an upside down recycling bin with a few 2x4s. The only part that was not clear was the brake lines and wiring harness on the drivers side had to be...

Hello. I have the Fabtech 3" lift with the UCAs and dirt logic remote reservoir coil overs. I really like it.

I added RCI Rock rails and really like the fit and finish. The company impressed me. They shipped the wrong hardware. I called them and Evan shipped the correct hardware by priority mail the same day. I am very happy with my purchase and would highly recommend them.

I purchased the Lobo Off Road kit to replace the crash bar and body mount. It was relatively easy to install and looks really good with my ADD bumper and skid plate. It also reinforces the bumper mount. I was impressed by the design and the quality of the part.

Just saw the passenger side in your note. Thanks again. I really appreciate the help.

Thank you! This has been driving me crazy. I never thought to look on the front. I think there is an AC evaporator on the front of my radiator. Is this on the passenger side?

Hi thanks for the fast response. I have the manual. After removing the front undershield, I cannot find the valve on the 2nd illustration. I am not sure where to look. I can't identify where that picture is.