Recent content by ksmich

the vehicle side of the harness already contains the neccessary wiring and pins, you would only need to do the bumper side

the "G- Harness" is in the bumper.

I dont think understand the question, The Headlamp switch uses a LIN bus to communicate with the BCM, the BCM then activates a FET that turns on pin 25 on harness C2280C. Based on the wiring diagram on the 2016 F150 PIN 25 on harness 2280C in not used, and I would suspect also not populated.

From what I can find, there is no wiring for the 2016 F150 to have rear fog lights. I suspect this is because the F150 is only designed for North American markets. where as the Bronco is based on the ranger which is sold around the world.

For me I use them as rear fog / additional rear lights in poor or dark conditions; so the using the rear fog switch is fitting. admittedly it is easier to just use the upfitter switches, but i was already replacing the factory headlamp switch for front fog lights, so the additional effort was...

Looks realy good! nice clean install!

I dont think any of us are familliar with the wiring on the F150 as this is a Bronco Forum, hopefully you are able to find the answer.

@Chritaka I am glad to see this mod worked for you. looks like a nice clean re-pinning of the connector.

Great Work, Glad to see someone was able to add a pin successfully. You may have had less issues if you were to disassemble / De-Pin the connector before drilling out the blank. Also, I wonder if there is a generic rubber seal you could use instead of silicone.

Sorry for my delay, I don't remember exactly the settings changed but I remember changing the BCM and IPC. Glad to see you were able to get them working

I understand that this was all in the fine print (That no one reads), but that doesn't make it right.

Beware, If you make Any reservation changes they will make you pay the new pricing for all guests, not just the added ones. I originally booked before the price increases and had one guest at $395 I ended up adding 2 more guests after the deadline and the system forced me to pay the new guest...

I'm right there with you. I took my Bronco on on Feb 6 for the manual trans TSB and was told this week that Ford Parts is expected to get the parts in mid April....

@nwGTS were you able successfully tapped into connector C424 with the mentioned terminal?

Yes, This is Correct