Recent content by Keerplunk

Sport mode on the bronco is nothing like the sport mode on the sports cars (well maybe the Raptor) Bronco sport mode is a glorified pedal commander and some gear shift holding

Adding King Coil overs to the rear and an Expedition one front bumper! Bumper will be before the rear coil overs (Yes I already have the Front ones installed)

My Bronco is named Bender from both the show Futurama and its a Big Bend.

Interested, I am in Burbank. Will take a couple weeks to pay for it. being the holiday season and all.

Where in CA?

I have a 22 NON SaS With an Expedition One Swing out tire carrier rear bumper. I am looking for rears, after watching the video I noticed you are attaching the rears to the end cap of the SaS extension. Do you have a set that comes with brackets or that mount more like the fronts?

Hell my upgrade to 35's was enough to have my tailgate popping. I have a big bend Non SAS so it had the weaker spare carrier. I ended up going the costly method and got the Expedition One rear bumper with swing out carrier. Maybe you could get away with the stock carrier if your Bronco came with...

Wolfbox Tri 900. Since I am mid package on my 22 I do not have a front cam from the factory. the Wolfbox has that covered and can record my off road adventures to the large onboard SD card...

Adams Drive shafts! Used them on my jeep and will be using them on the Bronco soon enough! https://www.adamsdriveshaftoffroad.com

Man I guess I would be so screwed if I put lower octane in mine! My Mileage sucks as it is! But I didn't buy it for its fuel efficiency!

Im sure the camera will be fine. I think there is only one part number for the camera anyway. It is the length of the tube. SAS wheels have a different offset I think. and the 35" is wider so they have to push it out from the door. I resolved it by installing an expedition one rear bumper with...

Yep, Have always names my vehicles! Current is Bender

Maybe I am wrong but one is JUST the center section and the other the Center and axle tubes. And 5.13 would be the way to go in my opinion assuming your not thinking of doing a ton of rock crawling

Just a bump for the edit. I really need this gone.

I figure it is to big for my SLA printer but I am going to test it tomorrow and see if I can print it out of high strength resin.