Recent content by Hapa

Looks great

Hello Trigger and fellow DIY'ers. Not having access to my bronco yet, I drew this based off interweb schematics (dangerous I know). Anyone that has a 2-door and is bored can verify the green measurements? Would have my eternal gratitude. Going to use these backgrounds to build a frame. Cheers all!

That looks might easy to take in and out. Thank you for posting that! Can I pick your brain? Do you have to tip the platform on edge to slide out the back? What I'm getting at is if there were 2xs that flanked the sides of the seats would there be clearance to slide it out the back or would the...

Do you happen to have the link to the hero who built the picture you linked? Would love to see if he is able to "Slide" the assembly out the back or if it catches on the rear door trim (aka more or less permanent)

So there is enough room to have a straight 2x between sidewalls and seats and have it run full length? I did not even consider that, I thought it would not fit. I see the advantage of both. Yours you can easily hinge the platform WITHOUT having to take the whole thing out. My design and the one...

Picture would be awesome! I assume you formed a "T" shape to keep it stable for the piece between the seats? My idea was for the side supports is to have 2 pieces of 1x or 3/4" ply and use these (or similar) furniture feet to contact the floor. Sadly this is all on paper until I actually have...

Great setup Trigger. I am designing a similar setup. I want to add support legs adjacent to the seats near the front. Do you think there is room? I know you mentioned you put some on the middle. Also wondering if you noticed any effects of the weight on the folded seats (squishing the seats...