Recent content by Greenbronc

The regular polymaker ht Pla prints with layer lines like any other filament. The GF version has them but you have to get really close to actually see them. There hasn’t been any change to the pockets. They’ve been installed since February. No flexing or warping. I’ve left bottles of water in...

Yes, Polymaker HT PLA GF. It came out with amazing quality. I used the Bambu wiki page to adjust the print settings. It wasn’t crazy changes but it’s the best print I’ve ever had.

Finally got a picture. Sat at Dfw north covered parking for about a week. On top of being parked outside 99% of the time. I had the top off a few days in a row before it got too hot. Other than putting some foam behind the passenger side they’re the exact same. Still need to make time to paint them

Still holding up well. I can get some photos as proof when I get back in town. To be fair they’re never in direct sun. But they seem to be the same as the first day I install them. Passenger side rattles some though.

Off topic, how do you like the ditch lights?

I would think so. It’s heated. No blis or blind spot monitor. Mine is as base as I could get it.

I know it came factory on a 2024 black diamond. The wolf box mirror pretty much has the same view field as the little blind spot did.

That’s the factory driver side.

I got mine installed this past weekend. Huge difference on the driver side, I didn't notice any difference on the passenger mirror. I tried to get 2 photos of the same area before and after the install, and one in traffic to show the wider view. Its weird compared to the narrow old view, but its...

Ordered the mirrors too. Would be nice to be able to see

The plastic brackets just hold the metal ones until the bolts are in. They do help line it up but the metal bracket can be lined up without them. There’s also a little pin that goes into the plastic brackets seems a little overkill. I had to lower the metal bracket for the interior trim pieces...

I’m not sure what those brackets are for. The plastic alignment pieces aren’t really needed. More of holder until the bolts are in. I have 2 sets of the plastic alignment brackets(one sets till in plastic bag). And 2 of the metal bracket the soft top bolts into. And also the rear panel trim...

I changed the fan speed to 100 and set it to stay on the entire time it printed, also adjusted the nozzle temperature and put the bed temp to 55c. I used poly maker ht-pla-gf. I searched the Bambu and poly maker site to find the best settings and combined them, no fuzzy skin. It came off the...

I’m not saying you should start a print farm, but it’s a very good print