Recent content by ejedmo5

I warn people about this but people love PETG, thanks now I have proof sorry that happened!

A local guy lasered his b pillar covers, I did a few things for mine with the laser too but typically on aftermarket parts like my tailgate table

Glad you like them! I need to reprint mine in 2 tone, I never thought to do that when designing it but have seen some great ones. I think there’s upwards 5000 made at this point which is wild to me. For those who have struggled to print them smooth plate and Asa is insanely good I’ve only had...

Ignore me they fit perfectly tried them on a local 2026 last night

Anyone with access to a 2026 bronco? I got 2 comments that the door pockets I designed don’t fit a 2026… curious if anyone can send me a picture of the door nets off so I can see the mounting holes to see if they’ve changed. Thanks!

Are you talking the front door pockets that I designed? I designed them so nothing needs cut. You should just take the 6 screws out keep the outer frame remove the net section (no cutting so it can be put back if desired) put the door pockets in and use the outer frame and 6 bolts to reattach it.

Agreed they weren’t that expensive, now my giant heap of trial and errors was adding up during development 😂

I get this question a lot on the small pocket, you by no means have to include it but I use it for a spare pair of sun glasses or pens, It just made more sense than having super deep pockets when I designed it. As for the library I strongly recommend passing on that, that's both expensive and...

They look fantastic I just didn’t want to do a permanent modification, glad you maintained the styling though!

I do but I made them before winter and haven’t had an opportunity to take them off this year, they should still fit in the bags

Glad you liked them! I’m shocked with how many people have made them at this point! I’m still thinking of a clever way to do the rears.

I think it was 8mm length is what I used no need for inserts, they have held great in my case. Those turned out great!

I did a cup holder for something else that had captive tpu inserts, could look at that looks great shocked at how many people have printed them, I do agree with adding some thing to keep them from rattling. Still not bad for me using a tape measure and cardboard for basically all of it 😂

May be a better job for adhesive backed rubber or felt or something.

I used this one so I could have a remote and change colors… I had to trim just a tiny bit where it entered the frame but otherwise pretty good Lamomo Led Strip Lights, 16.4Ft... https://www.amazon.com/dp/B0D5B69GF4?ref=ppx_pop_mob_ap_share